909 CSS9 Instruction Manual - Contents Of Carton
6
WARNING.
Before connecting a tool to a power source
(mains switch power point receptacle, outlet, etc.) be sure
that the voltage supply is the same as that specified on the
nameplate of the tool. A power source with a voltage greater
than that specified for the tool can result in serious injury to
the user, as well as damage to the tool. If in doubt, do not
plug in the tool. Using a power source with a voltage less
than the nameplate rating is harmful to the motor.
The tool must be used only for its prescribed purpose.
Any use other than those mentioned in this Manual will
be considered a case of misuse. The user and not the
manufacturer shall be liable for any damage or injury
resulting from such cases of misuse.
To use this tool properly, you must observe the safety
regulations, the assembly instructions and the operating
instructions to be found in this Manual. All persons who use
and service the machine have to be acquainted with this
Manual and must be informed about its potential hazards.
Children and infirm people must not use this tool. Children
should be supervised at all times if they are in the area in
which the tool is being used. It is also imperative that you
observe the accident prevention regulations in force in your
area. The same applies for general rules of occupational
health and safety.
The manufacturer shall not be liable for any changes made
to the tool nor for any damage resulting from such changes.
Even when the tool is used as prescribed it is not
possible to eliminate all residual risk factors. The following
hazards may arise in connection with the tool’s construction
and design:
•
Damage to the lungs if an effective dust mask is not worn.
•
Damage to hearing if effective earmuffs are not worn.
•
Always remove the plug from the mains socket before
making any adjustments or maintenance, including
changing the sandpaper.
WARNING.
We recommend the use of a residual current
device with a residual current rating of 30mA or less.
Wear goggles
Wear earmuffs
Wear a breathing mask
Contents of carton
The 909 CSS9 Detail Sander is supplied with the following
accessories as standard:
•
10 Sandpaper sheets,
5 x 80 Grit, 5 x 120 Grit
•
Dust extraction adaptor
Unpacking
Due to modern mass production techniques, it is unlikely
that your 909 Power Tool is faulty or that a part is missing.
If you find anything wrong, do not operate the tool until the
parts have been replaced or the fault has been rectified.
Failure to do so could result in serious personal injury.
Assembly
The 909 CSS9 Detail Sander is packed, fully assembled,
ready for use. You need only to add the appropriate sanding
sheet and dust extraction adaptor if necessary.