909 HT7102-AUOXY Instruction Manual - Troubleshooting
9
8. When the unit is properly connected and charging, the
battery charging LED will light to indicate the battery is
charging.
9. When the charging complete LED lights, the battery is
fully charged.
When disconnecting charger, disconnect AC cord, remove
clamp from vehicle chassis, and then remove clamp from
battery terminal.
Charging using the 12 volt dc charging adapter
1. Set the battery voltage selector to the correct voltage.
2. Insert the double barrel tip of the 12 volt DC charging
adapter cable into the battery charger.
3. Turn off ALL accessories in the car. Turn the ignition
switch of the car to the ACCESSORY POSITION
4. The power LED will light red to indicate that the charger
is plugged in and ready and turn on.
5. Insert the gold-tipped 12 volt DC charging adapter plug
into the vehicle’s 12 volt DC accessory outlet. Rotate the
adapter slightly to make sure there is good contact.
6. When the unit is properly connected and charging, the
battery charging LED will light to indicate the battery is
charging.
7. When the charging complete LED lights, the battery is
fully charged.
When disconnecting charger, disconnect AC cord, turn the
ignition switch to the OFF position, and then remove the 12
volt DC charging adapter from the vehicle accessory outlet.
Troubleshooting
Unit not charging
•
Check that the charger is properly connected to a live
240 volt AC outlet (the power LED will illuminate).
•
Check that the correct charge rate has been selected for
the battery being charged.
•
If the battery to be charged has fallen below 2 volts, the
battery cannot be recharged with this unit.
Care and maintenance
Storage
•
Store the unit in a clean, dry, cool place when not in use.
•
Clean the unit casing and cords (as necessary) with a
dry (or slightly damp) cloth. Ensure that unit is completely
disconnected from battery and power source before
cleaning.
•
To maintain the operating condition and maximize the life
of the charger cords, always coil them loosely for storage.
Do not wrap them around the unit or crimp them with a
tight band.
Fuse Replacement (12 Volt DC Charging Adapter)
1. Remove plug from accessory outlet. Remove the gold
cap by turning counterclockwise and lifting off.
2. Remove centre pin and spring. Remove fuse.
3. Replace fuse with same type and size fuse (5 amp).
4. Replace centre pin and spring inside plug.
5. Replace gold cap by turning clockwise.
Accessories
Recommended accessories for use with your tool are
available from your local dealer or authorized service centre.
If you need assistance regarding accessories, please
contact manufacturer at www.909.com
WARNING: The use of any accessory not recommended for
use with this appliance could be hazardous.