909 OSC400 Instruction Manual - Accessories
6
Never use damaged or bent blades. They will be brittle and
break easily possibly causing injury to the operator.
Never touch a saw blade immediately after using the tool.
The blade will be extremely hot and will burn your hand.
Only use accessories designed for use with this tool.
WARNING.
We recommend the use of a residual current
device with a residual current rating of 30mA or less.
Wear goggles
Wear ear muffs
Wear a breathing mask
Accessories
1 x 5 mm Hex key
1 x Plunge cutting saw blade for cutting softwood, plastic &
plasterboard
1 x Half circle saw blade for cutting soft metals, wood,
plastics & plasterboard
1 x Scraper blade
1 x Sanding pad
3 x Sanding sheets: 1 x 60 grit, 1 x 120 grit, 1 x 240 grit
WARNING:
Use only accessories that are recommended for
this oscillating tool. Follow the instructions that accompany
the accessories. The use of improper accessories may
result in injury to the operator or damage to the tool.
Before using any accessory, carefully read the instructions
or the owner’s manual for the accessory.
WARNING:
If any part is missing or damaged, do not plug
the tool into the power source or install any accessory until
the missing or damaged part is replaced.
Unpacking
Due to modern mass production techniques, it is unlikely
that your 909 Power Tool is faulty or that a part is missing.
If you find anything wrong, do not operate the tool until the
parts have been replaced or the fault has been rectified.
Failure to do so could result in serious personal injury.