909 P3059 Instruction Manual - page 12
12
•
Too much pressure being applied to the tool can also
cause the cutting disc to cut on an angle. Ensure the
beginning of the cut is a gradual start and apply the firm
and constant pressure as the cut gets deeper.
•
When cutting sections, always try and cut the sections
so as the actual cutting length is as short as possible
through the section. For example, angle iron has two
sections to be cut. If the material is cut where both
sections are cut at once, it is better for the cutting action
than trying to cut on thin section and then a long length
cut for the next section. The longer the length of cut,
the more chance of the cutting disc glazing and motor
overload.
Note.
As the disc wears the cutting capacity will decrease
and the depth stop knob may need to be adjusted.
Mounting the chop saw
to the bench top
The chop saw has the facility to
be bolted to the bench top using
two 10mm bolts. The fixing
points are down the center of
the base, one at the front and
one at the rear (Fig. V).
With the front hole, the bolt
needs to pass through the base from the top of the saw and
then through the bench top. The rear bolt needs to pass
through the bench top and then screw into the chop saw
base.
The thread for the rear is a 10mm x 1.5mm thread.
Maintenance
WARNING.
Always ensure that the tool is switched off and
the plug is removed from the power point before making and
adjustments or maintenance procedures.
Power cord maintenance
If the supply cord needs replacing, the task must be carried
out by the manufacturer, the manufacturer’s agent, or an
authorised service centre in order to avoid a safety hazard.
Cleaning
1. Keep the tool’s air vents unclogged and clean at
all times.
2. Remove dust and dirt regularly. Cleaning is best done
with a soft brush or a rag.
3. Re-lubricate all moving parts at regular intervals.
4. Never use caustic agents to clean plastic parts.
5. Remove the metal that may have built up around the
guard and spark deflector.
CAUTION.
Do not use cleaning agents to clean the plastic
parts of the saw. A mild detergent on a damp cloth is
recommended.
General inspection
Regularly check that all the fixing screws are tight.
They may vibrate loose over time.
V