Instruction manual pld3011 500w paint spr ayer and station.
2 specifications voltage: 230 – 240v~50hz rated power: 500w reservoir capacity: 700 ml operating pressure: 0.1- 0.2 bar flow rate: 800 ml/min viscosity: 40 din-sec nozzle: 2.5mm weight: 2.9kg description of symbols the rating plate on your tool may show symbols. These represent important information...
3 • to reduce the risk of electric shock, the manufacturer recommends the use of a residual current of 30ma or less at all times. 3). Personal safety • stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the infl...
4 • when working with the device inside and outside care must be taken that no solvent vapors are sucked into the device. • when outdoors observe wind direction. When working indoors ensure that there is sufficient ventilation. • do not spray at the device. • the device only splash-proof when the ai...
5 assembly attaching/detaching the paint pot holder 1. To attach the paint pot holder (18), insert the arms of the paint pot holder into the paint pot holder guides on both sides of the paint sprayer, and push the arms into the guides (19) until they clip into position and are secure. (fig a) 2. To ...
6 preparing for operation ensure you check and follow the below recommended steps before using your paint sprayer 1. Before connecting your paint sprayer to the mains supply, ensure that the supply voltage is identical with the value given on the rating label (on the side of the paint sprayer). Note...
7 using the paint volume control dial the paint volume control dial is used to increase or decrease the flow of paint being sprayed from the spray gun. For larger surface spraying, the maximum flow is recommended. For smaller surface spraying, the minimum flow is recommended. Note: before using the ...
8 11. Clean the outside of the spray gun and container with a cloth soaked in solvent or water. Remove and clean the suction tube. Use the supplied nozzle cleaner to unblock and residue in the 3 small holes on the base of the suction tube end. 12. Unscrew the air cap nut. Remove air cap .Clean the a...
