A&D HT-120 Instruction Manual - Errors
6
Errors
e
e
eeee
Overload. Remove object from the weighing pan.
------ Out of range or unstable error. There is a load beyond the zero
range at the power-on. When pressed the RE-ZERO key or
powered on, unstable weighing shows this display either.
lb
eeee
Low battery. Replace batteries with four new ones immediately.
Cal
ee
e Calibration error. Unstable weighing or incorrect calibration weight.
err
ee
# Internal errors (# will be 1, 2, 3, 4, 5 or 6). Request service.
FUNCTIONS
Entering the Function Settings
Turn the scale turned off and press the ON:OFF key while
pressing the RE-ZERO key. Then, the display will show the
software version p-1.00 (“1.00” is an example and may be a
different number.) This is the starting point of the function settings.
Key Operation
UNITS key
To select a function item.
RE-ZERO key To change the parameter of each item.
ON:OFF key
To finish the operation and turns off the scale.
Starting at the software version display, each function item appears
cyclically by pressing the UNITS key.
°
p-1.00
°poff 1
°Cond 1
°trc 1
°
Unit
°ltUp 3
°pnt 0
Press the RE-ZERO key.
To select the weighing units.
“
”, “
”, “ ” and “ ” show the movement by the UNITS key.
While the display shows function item, press the RE-ZERO key to
change the setting.
To finish the settings, press the ON:OFF key to turn off the scale.
°
Unit 2
°
Unit 1
°
Unit 3
°Unit
°Unit
°Unit
°Unit
°Unit
°Unit
°Unit
°Unit
°Unit