A&D Rechargeable Battery AD-1682 Instruction Manual

Summary of Rechargeable Battery AD-1682

  • Page 1

    Wm+pd4000270c.

  • Page 2

    This is a hazard mark (caution mark). © 2005 no part of this publication may be reproduced, transmitted, transcribed, or translated into any language in any form by any means without the written permission of a&d company ltd. The contents of this manual and the specifications of the instrument cover...

  • Page 3: Warning Definitions

    1 warning definitions the warnings described in this manual have the following meanings: caution a potentially hazardous situation which, if not avoided, may result in minor or moderate injury. It may also be used to alert against unsafe practice. Note an important description for proper use of the ...

  • Page 4: 1. Introduction

    2 1. Introduction 1-1 about the ad-1682 the ad-1682 is a rechargeable battery exclusively designed for a&d-manufactured balances. Using the ad-1682, a balance can be operated in a location where an ac power source is not available. Before use, see “1-4 list of applicable balances” to check which bal...

  • Page 5: 1-3 Specifications

    3 1-3 specifications battery mass approximately 1.3 kg operating temperature range +5 °c to +40°c (+41°f to +104°f) storage temperature range -20 °c to +40°c (-4°f to +104°f) operation hours approximately 8 hours (when operated continuously using a gx series balance. Operation hours depend on operat...

  • Page 6: 2.  Charging The Battery

    4 2. Charging the battery notes charging the battery before it is completely discharged will shorten the battery life. Whether the battery is completely discharged or not can be determined by the power supply led indicator when the charger and the battery are disconnected: indicator “on”= the batter...

  • Page 7: 3. Using The Battery

    5 3. Using the battery use the battery to supply power to the balance as follows: 1. After charging is complete, disconnect the charger from the battery. 2. Insert the output plug into the balance. 3. Turn the power switch to the “power supply” position. The power supply led indicator will be turned...

  • Page 8

    6 4. Battery condition and operation the combination of the power switch, charger, and led indicator conditions, leads to as shown below: power switch charger led indicators operation “charge” connected being charged. Approximately 15 hours to full charge. (see note 1). Power will not be supplied to...

  • Page 9

    7 memo.

  • Page 10

    8 memo.