334im 335im 336im pn# 319-1063 rev a 5/99.
2 19 declaration of conformity manufacturer’s name: analog and digital systems, inc manufacturer’s address: 300 wildwood avenue woburn, ma 01801 usa declares, that the product: product name: 334im 335im 336im conforms to the following standards: en 50 081-1/1992 en 50 082-1/3.1995 european contact: ...
3 18 table of contents introduction ........................................................................................ 3 about this manual .................................................................................. 3 features of your 3-series loudspeaker ...................................
4 17 features of your 3-series loudspeaker molded woofer basket - the back bone of any good woofer is it’s basket. It provides the proper alignment and support structure for the magnet while the very thin braces guarantee a minimum of early reflections off the basket that would be ordinarily transmi...
5 16 warnings and tips study your automobile thoroughly before you drill or cut any holes. Take extra care when working near gas tanks, gas lines, brake or hydraulic lines and electrical wiring. Wear eye and ear protection when using power tools. Keep the woofers and tweeters away from metal filings...
6 15 amplifier requirements a note on power handling each 3-series speaker system requires a minimum of 20 watts per channel to achieve reasonable listening volumes in a moving automobile without clipping the amplifier. A/d/s/ recommends 150 watts per channel as a maximum so as not to exceed the the...
Bi-wire connections to the crossover network connections to the woofer and tweeter are the same as the normal wiring method. Connect the amplifier to the tweeter to the terminals marked tweeter input. Connect the woofer amplifier to the woofer input terminals with another run of wire. Important note...
8 13 termination the woofer and the tweeter use .187 spade lugs for electrical connections. Use standard .187 female quick disconnects to attach wires to the speaker. Speaker mounting woofer installation the 3-series woofer will fit into standard factory mounting locations using the existing mountin...
9 12 crossover installation bi-wiring / bi-amping the 3-series allows conventional wiring, bi-wiring, or bi-amping using the supplied passive crossovers. While conventional wiring will provide excellent sound, bi-wiring or bi-amping will further enhance the performance in no-compromise systems. Bi-w...
10 11 rotating the tweeter grasp the knob on the back side of the speaker, and gently turn it to the desired position. A/d/s/ recommends that you start with the tweeter angled so it points directly at the listening area. Feel free to experiment with the position that gives you the most pleasing soun...
