Analog and digital systems 6 4 1 i s owners manual -3009 rev a ©2001 analog and digital systems, inc. 1.800.255.4434 www.Adst.Com.
1 introduction..................................................................................... 1 about this manual............................................................................ 1 features of your 6-series loudspeaker............................................... 2 warnings and ti...
15 ded woofer basket - the back bone of any good woofer is it’s basket. It provides the proper align- nt and support structure for the magnet while the very thin braces guarantee a minimum of early ections off the basket that would be ordinarily transmitted as sonic colorations through the cone. Ete...
3 study your automobile thoroughly before you drill or cut any holes. Take extra care when working near gas tanks, gas lines, brake or hydraulic lines and electrical wiring. Wear eye and ear protection when using power tools. Keep the woofers and tweeters away from metal filings and shavings. Once f...
13 ote on power handling h 6-series speaker system requires a minimum of 20 watts per channel to achieve reasonable lis- ng volumes in a moving automobile without clipping the amplifier. A/d/s/ recommends 150 watts channel as a maximum so as not to exceed the thermal or mechanical limitations of the...
5 fier about 1/4" from the end and insert into the connector input + and - positions and tighten the set screws. Strip the wire from the woofer and insert into the + and - positions for the crossover woofer output. Follow the same procedure for the connection to the tweeter. The 6-series passive cro...
11 nects to attach wires to the woofer. Tweeter is terminated with bare wire. Use insulated butt connectors, bullet connectors, or quick dis- nects to extend the tweeter wires to the crossover location. Alternatively you may solder all con- ions and insulate them with high quality heatshrink tubing....
7 wiring / tri-amping 6-series allows conventional wiring, tri-wiring, or tri-amping using the supplied passive crossovers. Le conventional wiring will provide excellent sound, tri-wiring or tri-amping will further enhance the ormance in no-compromise systems. Wiring uses three pairs of speaker wire...
9 inaccessible. Give some thought to the electrical connec- tions. You may be able to fish the tweeter signal wire to the crossover network location after installation of the tweeter assembly. You may need to fish a signal wire from the crossover network location to, and then through, the mounting h...
