Analog and digital systems ht60ic ht80ic owner's manual.
Table of contents i ntroduction 1 cautions 1 about this manual 1 features 1 installation precautions and tips 2 general mounting suggestions 2 prewiring 3 preparing the wall or ceiling cutout 3 installation preparation 3 final installation 4 custom painting 4 operation 4 specifications 5 warranty in...
Installation precautions and tips please read these instructions completely for the best enjoyment of your custom series speakers. • when you cut into the ceiling to install the speaker, do not cut through the facing or insulation that may be above the ceiling. This facing is a moisture barrier. Use...
Prewiring • check local building and electrical codes for compliance of the speaker wire. • use stranded wire of at least 16 gauge; for runs over 100 feet, it is preferable to use 14 gauge wire. • use only insulated staples or nylon tie straps to secure wiring within the wall to avoid shorts. • do n...
Final installation the speaker is held in place with four mounting clamps that are part of the assembly. When shipped from the factory the clamps are pivoted so they will fit into the mounting hole. When the mounting hole clamp screws are turned, the clamps pivot outward and are then drawn downward ...
Specifications ht60ic ht80ic frequency response (hz) 65-20 khz 58-20 khz impedance 4 ohm 4 ohm sensitivity 1w/1m (db) 88 db 88 db max bezel diameter 9-1/4" (23.5 cm) 10-7/8" (27.6 cm) mounting hole 7-11/16" (19.5 cm) 9-7/16" (24.0 cm) rear clearance 3-1/2" (8.9 cm) 4-1/8" (10.5 cm) recommended power...
Warranty information limited two year consumer warranty directed electronics, inc. Promises to the original purchaser, to replace this product should it prove to be defective in workmanship or material under normal use, for a period of two years from the date of purchase from the dealer as indicated...
A directed electronics, inc. All rights reserved g39630/35 8-03.
