A.J.Antunes SS-400TT User Manual - Surface Steamer Ss-400Tt
SURFACE STEAMER SS-400TT
7
P/N 1011073 Rev. H 12/13
McDonald’s
A.J. Antunes & Co.
OPERATION
Operating Instructions
1. Turn the power on and allow the unit to heat up.
NOTE: The display registers “LO” until the preset
operating temperature is reached. Once the unit is
heated up, the unit displays the cycle time.
2. When the unit is ready, select the desired steam
channel by pressing the appropriate button for
that channel.
3. Open the Bun Cap and place the heel and crown
cut side down onto Flipper. Close the Bun Cap.
4. Press the
ACTIVATION
button to begin a steam
cycle. The display counts down to zero and an
audio sound signals the end of the cycle.
NOTE: A new cycle cannot be started until the
audio signal is finished. To adjust the num-
ber of repetitions of the audio signal, see the
Programming section of this manual.
4. Open the Bun Cap and then lift the Flipper to
remove the buns from the steam area.
5. Complete the assembly of the sandwich.
Figure 4. Front View (Primary Control Panel View)
CAUTION
Buns will be hot after steaming! Lift the Flipper to
remove buns. Use caution to avoid burns.
OK
1
2
3
4
READY
STEAM
POWER
Heat Generators
(2 Pairs)
Bun Cap
(2 total)
Flipper
(2 total)
OK
1
2
3
4
READY
STEAM
POWER
Channels 1
through 4
Unit
Display
Steam
Activation
Button
Power
Button
Program
Button
Up
Arrow
Button
Down
Arrow
Button
OK
Button
Figure 3. Primary Control Panel View
NOTE: This unit has two control panels. You can
operate the steamer from either side of the unit.
However, you can only program the unit and turn
it on/off from the Primary Control Panel (Power
Switch side).
NOTE: The steamer returns to the default program
channel of #1 (See Figure 3) after completing a
steam cycle. For example, If you run a steam cycle
on channel 4, the steamer returns to channel 1 once
the steam cycle completes.