A-Link V100AP Quick Installation Manual - Advanced Security Level
ADVANCED SECURITY LEVEL
3. Modify wireless network settings.
Go to WIRELESS menu and choose
Channel/SSID/Security.
Change new name to wireless network (SSID)
and write it down to page 9.
Change SSID Broadcast to DISABLE
Note! Network name can not contain any
special characters or spaces.
Choose WPA/WPA2 to Allowed Client Type.
Change below settings to WPA/WPA2 menu.
Cypher suite = Mixed
Authentication = Pre-shared Key
Pre-shared key type = Passphrase (8~63 characters)
Pre-shared Key = < Type password here >
Press Save Settings bottom-edge of the page.
Note! Type Pre-shared Key about 8 - 63 characters long
password. Write your password to page 9 for future use
with your computer.
In WIRELESS menu choose Access Control.
Choose Yes to Enable MAC Filtering. Choose Allow to
Access Rule for registered MAC addresses. Enter
wireless LAN card MAC addresses from all computers
which will access to this access point. (Wireless LAN card
MAC can be found ex. in Win2000/XP with IPCONFIG
/ALL command)
When you have added all MAC addresses, press Save
Settings bottom-edge of page.
Note! Check MAC addresses from your computer Wireless
LAN adapter on Wireless Network Connection. Do not
add modem MAC address to this list.
Note! You can also press Add currently associated MAC stations button, when all computers connected
wirelessly to AP will be added automatically to the access list.
You can remove network cable now. Wireless network will work right when WPA/WPA2 encryption
password is entered to computer wireless network settings. You can find instructions from pages 12 - 13.
11