A-Neu Video ANI-MOD Series Instruction Manual - page 9
7
FRONT PANEL
ANI-MOD1616/ANI-MOD3232/ANI-MOD6464
The switcher models ANI-MOD1616, ANI-MOD3232, and ANI-MOD6464 share the same function buttons, the only difference is the chassis height
and number of I/O’s.
The front panel of ANI-MOD1616/ANI-MOD3232/ANI-MOD6464 is shown as below:
The front panel can be divided into the following sections:
1) Indicators:
• Power LED to indicate that the system is on.
• IR reception port for use with remote control.
2) System monitor: shows system switching and status information
3) Input and output selection buttons: for selecting inputs and outputs for your unit. All switches are backlit in green.
4) Command button menu: for controlling functions of your unit. All switches are backlit in green.
Button Description of ANI-MOD1616/ANI-MOD3232/ANI-MOD6464
Buttons
Function Description
....
“0” to “9”
Input buttons. These buttons are used to select the input channel(s) for the action to be programmed.
....
“0” to “9”
Output buttons. These buttons are used to select the output channel(s) for the action to be programmed.
AV Synchronal Button:
Used for programming the switcher to transfer video and audio signal synchronously
(together). Please note that for the audio to be switched requires that the input and output boards are of a format
that also contains audio connectivity.
Division Button:
Used to divide the output channels when switching to more than one channel.
Example:
To select output channels 3 and 4 for switching.
Operation:
Press output buttons in this order - “3,” “,” “4”
Confi rmation Button:
Confi rm the switching operation. The operation will not be executed by the matrix without
confi rmation. This button needs to be pressed at the end of each command given.
All Button:
To transfer a single input channel to all output channels or switch off all the output channels.
Example 1:
To transfer video and audio signals together from input channel No.12 to all output channels.
Operation:
Press buttons in this order - “12”, “ALL”
Example 2:
To transfer all input signals to the corresponding output channels respectively. In other words, to
have
1->1, 2->2, 3->3, 4->4…16->16…
Operation:
Press buttons in this order - “ALL”, “THROUGH”
Through Button:
Used to transfer the signals directly from the input channel to the corresponding output
channels (channel with the same number). It can also be used in conjunction with the “All” button to switch all
channels to their corresponding output channel.
Example 1:
To transfer the signals from input channel No. 3 to it’s corresponding output channel.
Operation:
Press buttons in this order - “3”, “THROUGH”
Example 2:
To transfer all input signals to the corresponding output channels respectively. In other words, to
have 1->1, 2->2, 3->3, 4->4…16->16…
Operation:
Press buttons in this order - “ALL,” “THROUGH”