Ani-pa mini digital amplifier with eq/mixer instruction manual frisco, texas 75034 (317) 456-2461 v.2.1.
Table of contents safety precautions please read all instructions before attempting to unpack, install or operate this equipment and before connecting the power supply. Please keep the following in mind as you unpack and install this equipment: • always follow basic safety precautions to reduce the ...
Introduction & contents introduction ani-pa is a compact-size digital amplifi er (class-d) with 3 inputs (2 line level and 1 mic). It is integrated with many useful functions, including volume control, bridge connection to additional ani-pa’s, dual-mono, eq control, microphone mixer, etc. It is desi...
Features features 1. Two stereo audio inputs, switchable by push-button, rs-232 & ir remote (optional). 2. Volume/bass/treble controllable by push-button, rs-232 & ir remote (optional). 3. 2x20watt@4 ohm as the default amplifi er output. 4. Line audio output at 3.5mm jack, with volume controllable. ...
Specifications specifications audio input audio output input 2 stereo audio 1 mic output 1 amplifi er 1 stereo audio input connector 2 rca 1 3.5mm jack 1 captive screw connector output connector 1 captive screw connector 1 3.5mm jack audio input impedance >10kΩ audio output impedance 50Ω/stereo, 4~8...
Audio connection audio output default output: 2x20watt@4 ohm the default output of the amplifi er is 2x20watt@4 ohm, so user can connect the amplifi er in stereo. As the picture below: connecting all four pins. Bridge connection: 1x40watt@8 ohm the ani-pa has the bridge connection, to double the out...
Audio connection cont’d microphone input the microphone input of ani-pa has three modes, and different modes use different connections, as the picture below: 48v phantom power input when the switch is set to “48v”, the mic input will provide a 48v phantom power. This is usually used for power supply...
Buttons control the buttons provides control of volume/eq and switching. Audio switching there are two switchable stereo audio inputs, one 2xrca input, and one 3.5mm jack input, switchable through the buttons as below: volume/eq controlling the line volume and mic volume can be controlled by the but...
Rs-232 cable pins used 1. Transmission rate: 9600 bps 2. Data format: 8 data bits, no parity , 1 start bit, and 1 stop bit 3. Flowing control: none also known as 9600,8,n,1 7.
Rs-232 communication protocol note: 1: the letter inside the bracket [ ] is the variable code, which is changeable. 2: the bracket [ ] is not part of the command. 3: any dot “.” after the letters is part of the command. Example 1: switch the input 2 to the line out. Rs-232 command: [2a1.] example 2:...
System diagram / panel drawing system diagram panel drawing 9 end of document rs-232 control panel optional ir receiver & remote (87 mm) (38 mm) (96 mm) (123 mm).
