A.R.North America AR610 Blue Clean User Manual

Summary of AR610 Blue Clean

  • Page 1

    Ar610 blue clean u se • m aintenance m anual warning: this manual must be read before installation or use of the unit. A.R. North america attn: pressure washer warranty department 140 - 81st avenue ne fridley, mn 55432 place stamp here.

  • Page 2

    Key 1 - water outlet (outlet) 2 - water inlet with fi lter (inlet) 3 - high pressure rotating nozzle kit (optional accessory) 4 - adjustable spray nozzle 5 - maintenance handbook 6 - power supply cable with plug 7 - lance 8 - gun with safety catch 9 - high-pressure hose 10 - nozzle cleaning tool 11 ...

  • Page 3: Notes

    Notes 1. I ntroduction the high pressure power-jet cleaner you have purchased is a technologically advanced product designed by one of the leading european manufactures of high-pressure pumps. To obtain the best performance from your unit, read this booklet carefully and follow the instructions each...

  • Page 4

    Pos. Code description qty. Pos. Code description qty. Kit 2767 17 2 22 1 27 3 34 1 35 1 37 1 40 1 49 3 51 1 60 1 63 5 69 5 72 1 o-rings pos. Qty. 1 1340700 black post. Casing 1 2 1261560 screw 2 3 1260760 screw 4 4 1200430 screw 8 5 1340811 black plug 1 6 1260351 tank plug 1 7 390210 o-ring 1 8 1342...

  • Page 5: Ar610

    Ar610 always use two hands when operating a pressure washer. This will assure complete control of the equipment. Always test the gfci plug prior to using the cleaner. Never test the pressure of the cleaner against any part of the body. Use the trigger lock whenever the spray gun is not being used fo...

  • Page 6

    Nozzle worn or wrong type. Replace nozzle. Water fi lter clogged. Clean fi lter water supply pressure low. Open the water supply tap fully. Air begining sucked into the system. Check that hose fi ttings are tight. Air in pump. Switch off the cleaner and operate the gun until a steady fl ow of water ...

  • Page 7

    6.3 long periods of non-use may lead to the formation of lime scale deposits. Working through the hole on the rear, release the motor using a screwdriver (for models with this feature). Then remove the screwdriver and proceed with the restart operations. - except for the extreme - 6.4 clean the nozz...

  • Page 8

    5.6 correct use of the rotary nozzle (where fi tted) 5.6.1 for increased washing power, use the rotary nozzle kit as follows: 5.6.2 turn off the high pressure cleaner. 5.6.3 unscrew the adjustable head and fi t the rotary nozzle onto the lance. 5.6.4 turn the high pressure cleaner back on. 5.7 recom...