A SYSTEMS DMP81 User Manual - 3. Controls and Connections
3
English
DMP81
1. Input Level Control 1 - 8
Every input channel is equipped with a rotary knob for
adjusting the final input level.
2. ON LED 1 - 8
Every input channel is equipped with an ON LED
which lights green when a signal is present in the input
channel, and will turn red when the signal peaks
3. HPF (High Pass Filer) Control 1 - 8
Make adjustment by using slot screwdriver
4. High Frequency Shelving Filter 1 - 8
Make adjustment by using slot screwdriver
5. AUX Level Control
This rotary knob for adjusting the AUX input level
6. SG LED (for AUX INPUT)
This LED will light up green when an output signal is
present and red when the signal peaks
7. AUX INPUT 1/4” TRS Phone Jack
8. LIMITER LED (for MASTER OUTPUT)
Lights red when on-board limiter actives
9. SG LED (for MASTER OUTPUT)
This LED will light up green when an output signal is
present and red when the signal peaks
10. MASTER Level Control
This knob controls the level for MASTER output
11. POWER LED
This LED indicator will illuminate when the DMP81 is
activated
12. Power switch
Flick this switch to switch the unit on and off.
13. PHONES Level Control
This knob controls the level for the PHONES output
jack
14. PHONES OUTPUT 1/4” TRS Phone Jack
For connecting headphone
3. CONTROLS and CONNECTIONS
FRONT PANEL
15. AC Power Connector
The unit is supplied with power via a standard IEC
power cable from power source
16. DIP Switch 1 (for adjusting setup options)
See section “DIP Switch”
17. DIP Switch 2 (for turning phantom power ON/OFF)
See section “DIP Switch”
18. MASTER OUT
DMP81 offers a single 3-pin Euroblock output
connector This connector can be set as balanced or
unbalanced (see section Installation and Setup)
19. INPUT Connector 1 - 8 (Euroblock)
See section “Installation and Setup”
20. INPUT Connector 1 - 8 (Balanced 1/4” TRS Insert
Jack)
See section “Installation and Setup”
21. MIC-IN/LINE-IN Switch
Every input channel is equipped with a button switch
for setting MIC-IN/LINE-IN For MIC-IN, set this button
to MIC, for LINE IN, set this button to LINE