A+V Link Technologies PowerHDLink AVM-6985H-SYS-A1 Quick Setup Manual - page 5
A+V Link Technologies
PowerHDLink Quick Setup Guide
©2009-2011 Copyright by A+V Link Technologies, Corp.
Version 2.2
5
Step 6: Turn on power switches
Turn on the Power Switches on the rear panels of both Rx and Tx.
Wait for about 10 seconds.
A red Power Indicator light will illuminate on the front panel of both
the Transmitter and Receiver. The Source LED indicator on the Tx
will show which of the available input connectors is currently in use
Source LED indicators on front panel:
1
HDMI connector 1
2 HDMI
connector
2
3 HDMI
connector
3
AV1 CVBS/S-Video
AV2 YPbPr
connectors
In our example we connected the Blu-Ray player to HDMI #3,
so the Source LED indicator “HDMI 3” should illuminate.
4 Video Source Remote Control
With the PowerHDLink system, you can control your video player from the remote location (i.e. where
Rx is located), using the Video Player’s remote controller (must be Infrared Remote Controller). The
Rx is fitted with an IR sensor that receives the signals and sends them over the power lines to the Tx,
where the Tx re-emits the same IR signals to the video player.
Power LED
Source LED
indicators