Summary of MyM Pro T2
Page 1
Mym pro t2 installation guide.
Page 2
22 1. Introduction 2. Unpacking the unit 3. Connections and indications 4. Ip settings 5. Menus and settings web ui 5.1 overview menu 5.2 input settings 5.3 output settings 5.4 service management 5.5 ci menu 5.6 system options 6. Installation and configuration examples 7. Technical specification mym...
Page 3
33 thank you for purchasing an a2b electronics product. The mym pro t2 is a revolutionary solution for reception and modulation both from satellite or from terrestrially transmitted tv content into an analogue format suited for small smatv networks where cost efficiency and high quality is required....
Page 4
4 4 the following items are included in the package: amount description 1 mym pro t2 1 quick guide every unit is quality controlled by us before delivery. Should any items be missing when unpacking, please contact our support service (see page 3 for contact info). English 2 unpacking the unit 4 4.
Page 5
55 english 1. Antenna input 1 connect the satellite/terrestrial signal for ch1 and ch2 here 2. Antenna input 2 connect the satellite/terrestrial signal for ch3 here 3. Common interface 1 insert a common interface module into this slot (supports decryption for channel 1 and 2) 4. Common interface 2 i...
Page 6
6 the mym pro t2 has an embedded web server allowing web browser internet explorer to connect to the unit for settings and management. No controller software is needed. The mym pro t2 has by default static ip address(es) for connecting your pc to the unit. Note! Mym pro t2 is only approved with inte...
Page 7
77 english select [use this ip adress] and write: 192.168.0.19 and select [net mask] 255.255.255.0. Click [ok] and then click [close]. Note! For pc with other operating systems (os) than windows, please consult the owners manual for your pc for [ip/network settings]. Connecting your pc to the mym pr...
Page 8
8 english 5.1 overview menu current settings contains information of current input and output signals, if the tuners are locked to a signal, firmware version, bootloader version, hardware revision, serial number and current ip network settings. All necessary settings can be made in the web gui via a...
Page 9
99 english 5.2 input settings as the mym pro t2 contains ”multituner” start by selecting either dvb-t/t2 or dvb-s/s2. After that you choose [tuner 1] or [tuner 2] for settings of the tuner parameters. Tuner 1 provides the service list for rf output ch1 and ch2. Tuner 2 provides the service list for ...
Page 10
10 10 english 5.2 input settings cont. For receiving from satellite, start with chosing [tuner 1] or [tuner 2]. Tuner 1 provides the service list for rf output ch1 and ch2. Tuner 2 provides the service list for rf output ch3. The tuner can also be ”disabled”. Select the actual input parameters for t...
Page 11
11 english 5.3 output settings modulation band start the output setup by selecting which band you want to use. You can select vhf-7, vhf-8 and uhf. Vhf-7 and vhf-8 corresponds to 7 and 8 mhz bandwidth. After selection press [set]. Frequency for each of the 3 (or 6) possible rf output channels, set t...
Page 12
12 english advanced aspect ratio set correct picture format of the programs transmitted from the mym pro t2. Video standard select your regional video standard. Audio system set your regional audio standard. Video watchdog here you can switch the video wd on or off. This can be useful for example if...
Page 13
13 english 5.4 service management the mym pro 3t contains 2 and for mym pro 6t 4 separate dvb-t tuners and totally 3 or 6 services can be selected for each of the output channels, named [ch-1], [ch-2] and [ch- 3] and for mym pro 6t also [ch-4], [ch-5] and [ch-6]. The list of services presents all re...
Page 14
14 english 5.5 ci menu the mym pro 3t contains 2 ci (common interface) and mym pro 6t contains 4 ci (common interface). [ci-1] decrypts services for output ch-1 and ch-2. The [ci-2] decrypt services for output ch-3. In mym pro 6t [ci-3] decrypt services for ch-4 and ch-5 and [ci-4] decrypt service f...
Page 15
15 5.6 system options upload/upgrade the upgrade menu is used to be able to download software upgrades or future software functionality. The procedure of downloading a new software looks as described below: 1.Download the appropriate file from our web page to your pc. 2.Browse for the file in the my...
Page 16
16 16 the mym pro t2 can be installed either as a stand alone unit directly on the wall by the use of a dedicated mym pro t2 wall mount brackets (part number 702800.10) or in an 19 inch cabinet. Before connecting power to the mym pro t2, make sure that all other connections have been made. A coaxial...
Page 17
17 17 english 2 / 4 x dvb-t terrestrial receiver 3 / 6 x modulator 3 / 6 x mpeg decoder – video - audio miscellaneous ac power supply 230 vac typ (94-264vac) ac power consumption 3t typ. 18 w ac power consumption 6t typ. 36 w ethernet port setup and update setup web based gui dimension 383x220x44 mm...
Page 18
18 18 the document for declaration of conformity is available for download from www.A2b.Se . Further information at www.A2b.Se. English 8 declaration of conformity.
Page 19
19 english dvb digital video broadcasting (standardization body) mpeg-2 compression format for digital tv mpeg-4 compression format for digital tv (sd and hd) dsb double side band (rf modulation occupying 2 channels) nicam digital sound format for analogue tv transmission ip internet protocol (defin...
Page 20
651453.01 rev a fw 1.0 a2b electronics ab p.O. Box 14 • se-591 21 motala • sweden phone +46 141 229100 • fax +46 141 229101 e-mail market@a2b.Se www.A2b.Se 655312.01 rev f fw 2.1sr4.