AAD 7001 Owner's Manual

Summary of 7001

  • Page 1

    7001 loudspeaker owner s manual '.

  • Page 2

    Aad 7001 owner s manual thank you for choosing the 7001 loudspeaker system. This is our most advanced high performance loudspeaker ever to come out of the aad stable, a true thoroughbred based on the design philosophy of phil jones, a loudspeaker that produces a corresponding acoustic output to exac...

  • Page 3

    Your head should be at same height as center of speakers wiring up your speakers speakers and electronics terminals have corresponding (+) and (-) terminals. It is important to connect both speakers identically: (+) on the speaker to (+) on the amplifier and (-) on the speaker to (-) on the amplifie...

  • Page 4

    How to get the most out of your 7001s no matter how good all your audio components are, their performance will only reach whatever condition the room they dictate. Apart from the qualities of room acoustics, one of the major contributors to audio degradation is room noise which will not only affect ...

  • Page 5

    The c-curve is "flat , but with limited bandwidth, with -3 db corners of 31.5 hz and 8 khz, respectively. " 1-4 dynamic range many recordings boast a dynamic range of 100db or more but this is meaningless if you are using your playback system in a typical room. If you are playing a speaker with a hi...

  • Page 6

    As a rule of thumb rooms that have ratios of dimensions to the following numbers will tend to have a more linear spread of room modes therefore be more neutral sounding. 1 : 1.14 : 1.39 1 : 1.28 : 1.54 1 : 1.6 : 2.33 reverberation decay of listening rooms (rt60) in simple terms, reflectivity is the ...

  • Page 7

    1-6 to illustrate this concept, think of the room as a small box. If the box is made of cardboard, the walls vibrate easily. The same box made of concrete would exhibit little movement. Diaphragmatic action dissipates low frequencies, robbing the bass of both impact and extension. Therefore, the mor...

  • Page 8

    1-7 amplifier power we recommend that you use an amplifier with power rating at least a 100watt rms or ideally 300watts plus per channel. These 7001s have a vast dynamic range and using a large power amplifier to power them will allow them to reach their full potential. Amplifiers with up to 1000 wa...

  • Page 9: General Care

    1-8 general care when cleaning the 7001 speakers, use clean, lint free and slightly damped soft cloth to remove surface dust from cabinets. Use a very clean and dry soft cloth to carefully remove dust from drivers. Make sure there are no abrasive particles in the cloth, or they may leave scratch mar...

  • Page 10

    Www.Philjonespuresound.Com american acoustic development llc.