AAD Silver-1 Owner's Manual

Manual is about: Silver Reference LOUDSPEAKERS

Summary of Silver-1

  • Page 1

    Silver reference loudspeakers owner s manual ' caution read the following before using these speakers: to assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. Install the speakers in a cool, dry, clean place away from windows, heat sources, ...

  • Page 2

    Do not attempt to clean the speakers with chemical solvents as this might damage the finish. Use a clean, dry cloth. Do not attempt to modify or fix the speakers. Contact qualified service personnel when any service is needed. The cabinet should never be opened for any reasons. Note: this speaker is...

  • Page 3

    Silver reference products refer to page 9~10 for specifications silver-7 silver-5 silver-1 silver-3c sr-1 sr-2 -3- s-160

  • Page 4

    Metal base x 1 m10 *40 machined screws (with spring washers) x 1 metal feet x 4 disc x 4 alan key x 1 parts list for each base base assembling instructions(only for silver-5 & silver-7) step 1 step 2 step 3 step 5 step 6 -4- step 4 step 1: stand speaker upside down, with protective foams on both end...

  • Page 5

    Placing the speakers two channel stereo application for stereo listening, you may choose any one pair of bookshelf or floor standing model. The size of speakers should be determined by the size of your living space so that they can provide sufficient volume. The two loudspeakers should be placed an ...

  • Page 6

    Note: make sure your amplifier is off and disconnected from power while you are connecting speakers to amplifier. Turn your amplifier on only after you check and make sure speakers are properly connected. Two channel stereo application connections are made at the terminals located on the back of the...

  • Page 7

    Bi-wiring bi-wiring increases the flow of current and will usually improve the sound quality. This method uses two pair of cables: one pair for the upper two terminals and one pair for the bottom two terminals (see fig. 2). Connect the speakers to amplifier the same manner as you do single wiring. Y...

  • Page 8

    Removing the grille the grille is attached to protect the speaker unit, but you can remove it if necessary. Hold the speaker with one hand, and pull the grille gently with the other to remove it. Notes: when removing the grille, be careful that you don’t touch the drive units, and don’t exert excess...

  • Page 9

    Specification silver reference specifications standard finish: high gloss cherry / piano black high gloss maple / metallic silver optional finish: high gloss rosewood / piano black piano black model: silver-1 sensitivity (1 watt @ 1m): 87 db impedance: 6 ohms (compatible with 8 ohm amplifier load) f...

  • Page 10

    Silver subwoofer specifications model: silver-160 amplifier type: solid state class a/b power: 200 watts continous into 4 ohms woofer: 10" aad designed high excursion frequency response: 23 hz to 160hz +/3db electronic crossover: continuous variable from 30hz to 160hz phase control: 0 -180 variable ...