Aardee AARF-30 User Manual - page 7
How to recharge
Open the cord cover.
Plug the power cord to the receptacle of AC power supply.
When charging the indicator turns red and when it is fully charged, the light turns green.
Once fully charged, unplug the power cord from the socket.
Normal recharging time for maximum usage is approximately 20-24 hours.
How to replace the battery
Take off the cover at the bottom by unscrewing it.
Unscrew the battery holder strip and remove it.
Take out the battery and replace it with the new one.
Reassemble the unit in reverse order.
Cleaning & Maintenance
Unplug the power cord properly.
The unit must be cleaned using a damp cloth with either water or mild detergent. Never
use strong chemicals since it will damage the plastic parts.
To clean the propeller, open the fan grill or cover holders to release the front cover.
To avoid damage, use only specified battery. See Specifications.
To prevent electric shock, do not open the unit unless you are qualified to do so.
Troubleshooting
Below are some common queries on the appliance. Please read and understand the basic
steps as it may save you time. If your concern is not found on the list or your issue persists, then
kindly call our service centre.
ISSUE
POSSIBLE CAUSES
SOLUTION
Not turning on
Power cord is not
plugged in.
The power cord is
faulty.
The power switch is not
on.
Power socket is faulty.
The power supply does
not meet the required
voltage of the unit.
Plug into the wall
socket and turn on.
Plug into another wall
socket.
If problem remains, call
service center.
Fan not rotating
The AC/DC switch is not
set correctly.
The speed switch is set
to off.
If using the main power,
set it to AC mode then
set the speed to high or
low.
If using the battery,
make sure it is
recharged and set to
DC mode. Set the
speed to high or low.
Operational noises
The knob or fan covers
are loose.
The unit is put in an
uneven place.
Unnecessary materials
are inserted.
Check for materials
attached or inserted.
Place the unit on a flat
surface.
Check the fan covers.
Tighten it if necessary.
4