AAS Ascent T1 Quick Start Manual
1
Carefully unpack box.
1 of 4
START HERE
2
Unlock and open front panel of unit
for access to internal components.
QUICK START
GUIDE
What’s what?
All the important components
labeled for you
Reset Button
For performing hard reset
Speaker Connector
Speaker can be disconnected temporarily
if unit is intermittently beeping. This is usually
due to a SIM card that is not yet activated.
SIM Card
If you have your own SIM card, see
page 4
and follow the instructions entitled,
Installing a Custom SIM Card
.
Antenna Cable
Camera Mounting Location
For future camera kit or third-party camera
Terminal Block
For wiring to gate operator or door opener
WARNING!
AUTOMATIC GATES CAN CAUSE
SERIOUS INJURY OR DEATH!
ALWAYS CHECK
that the
GATE PATH IS
CLEAR BEFORE OPERATING
!
Reversing or other safety devices should
ALWAYS BE USED
!
Continued on next page...
Unit shown with front panel fully open.
Internal wiring not shown for clarity.
IMPORTANT!
r
Ascent
WILL NOT WORK
until the
activation process is
COMPLETE
!
Follow the
Activation Guide
or call
Summit Control
at
(844) 259-8265
to
activate your unit.
Please use
all four screws
when
mounting unit to a pedestal; leave the
“hockey puck” antenna in place, even if
using the extension; and seal any holes
or gaps created in the enclosure.
Failure to follow these instructions
can result in damage to the unit!
CAUTION!
We recommend mounting Ascent T1 on a
gooseneck pedestal with the included hardware.
If using alternate mounting, the optional
Ascent 10' Cable Extension
(
p/n 16-X-EXT
)
should be purchased. Follow the instructions
included with the extension before moving on.
Failure to do so may result in no signal!
IMPORTANT!
r