Summary of AAC-2022TI
Page 1
High-definition ir water-proof bullet camera user manual.
Page 2
High-definition ir water-proof bullet camera·user manual 1 1 thank you for purchasing our product. If there are any questions, or requests, please do not hesitate to contact the dealer. This manual applies to aac-2022ti bullet camera. This manual may contain several technical incorrect places or pri...
Page 3: Regulatory Information
High-definition ir water-proof bullet camera·user manual 2 2 regulatory information fcc information fcc compliance: this equipment has been tested and found to comply with the limits for a digital device, pursuant to part 15 of the fcc rules. These limits are designed to provide reasonable protectio...
Page 4
High-definition ir water-proof bullet camera·user manual 3 3 2002/96/ec (weee directive): products marked with this symbol cannot be disposed of as unsorted municipal waste in the european union. For proper recycling, return this product to your local supplier upon the purchase of equivalent new equ...
Page 5: Cautions:
High-definition ir water-proof bullet camera·user manual 4 4 safety warnings and cautions please pay attention to the following warnings and cautions: hazardous voltage may be present: special measures and precautions must be taken when using this device. Some potentials (voltages) on the device may...
Page 6: Power Cord Requirements:
High-definition ir water-proof bullet camera·user manual 5 5 attached is also connected to properly wired grounded receptacles and are approved medical devices. Power connect and disconnect: the ac power supply cord is the main disconnect device to mains (ac power).The socket outlet shall be install...
Page 7: Perchlorate Material:
High-definition ir water-proof bullet camera·user manual 6 6 perchlorate material: special handling may apply. See www.Dtsc.Ca.Gov/hazardouswaste/perchlorate . This notice is required by california code of regulations, title 22, division 4.5, chapter 33: best management practices for perchlorate mat...
Page 8: Lead Content:
High-definition ir water-proof bullet camera·user manual 7 7 lead content: please recycle this device in a responsible manner. Refer to local environmental regulations for proper recycling; do not dispose of device in unsorted municipal waste..
Page 9: Safety Instruction
High-definition ir water-proof bullet camera·user manual 8 8 safety instruction these instructions are intended to ensure that user can use the product correctly to avoid danger or property loss. The precaution measure is divided into “warnings” and “cautions” warnings: serious injury or death may o...
Page 10
High-definition ir water-proof bullet camera·user manual 9 9 responsibility for problems caused by unauthorized repair or maintenance.) to reduce the risk of fire or electrical shock, do not expose this product to rain or moisture. this installation should be made by a qualified service person a...
Page 11
High-definition ir water-proof bullet camera·user manual 10 10 the sensor may be burned out by a laser beam, so when any laser equipment is being used, make sure that the surface of the sensor will not be exposed to the laser beam. do not place the camera in extremely hot or cold temperatures (t...
Page 12: Table Of Contents
High-definition ir water-proof bullet camera·user manual 11 11 table of contents 1 introduction ................................................................ 12 1.1 product features ................................................ 12 1.2 product appearances ..........................................
Page 13: 1 Introduction
High-definition ir water-proof bullet camera·user manual 12 12 1 introduction 1.1 product features this camera adopts a high-sensitivity sensor and advanced circuit design technology. It is possessed of high resolution, low image distortion and low noise features, which are suitable for supervisory ...
Page 14: 1.2 Product Appearances
High-definition ir water-proof bullet camera·user manual 13 13 1.2 product appearances three-axis adjustment: the pan axis range is 0~360°, tilt axis range is 0~75°, and the rotation axis range is 0~360°. Bracket mounting base power cable video cable zoom focus.
Page 15: 2 Installation
2 installation 2.1 installation before you start: when mounting the camera, for the cement wall, you need to mount the base with expansion screws. For the wooden wall, you need to mount the base with self-tapping screws. Please ensure that the wall is strong enough to withstand more than 3 times the...
Page 16
This series of bullet camera is equipped with installation bracket, and usually wall installation is preferred, here we will take wall installation as an example to explain how to install the device. Steps: 1. Drill the holes on the wall with the supplied drilling template. 2. Route the cables insid...
Page 17
Note: you must loosen the lock screw or fixed ring before adjustment and tighten it when you adjusted it. 2). Rotate the panning table to adjust the panning position of the camera. The adjustable range is from 0 degree to 360 degrees. 3). Rotate the tilting table to adjust the tilting position of th...
Page 18
Figure 2-2 adjusting the lens focus zoom.