Aasset ASTKJ-1201P User Manual - System Installation
Manual is about: WTX-1200A keyboard
of
18
CHAPTER 2.
SYSTEM INSTALLATION & TYPICAL APPLICATIONS
System Installation
Keyboard Installation -
Before you start connecting the keyboard equipment to your
system, make sure the units to be controlled are completely
installed and everything is working correctly. Before use of this
keyboard, you should set the protocol and baud rate
(2.4~57.6kbps) in the PTZ SETUP mode.
Use the following steps to set the communication protocol and
baud rate.
PTZ SETUP
PTZ SETUO -
PTZ Setup mode, select 1+ ,(2~3 seconds)
setup screen allows you to make change ench programmable clause.
Note: The baud rate must be the same between the controlled unit and
the keyboard.
User Manual - ASTKJ-1201P - AASSET SECURITY