AAT max-e Operator's Manual - Max-E
2
Mounting and initial operation
Max-e may only be operated in connection with a special holding device,
which must be fixed to the wheelchair.
These brackets (holding devices) must be mounted to the wheelchair exclu-
sively by AAT Alber Antriebstechnik or their authorized dealers.
2.1
Brackets
The holding devices or brackets are specially developed and adjusted to
each particular type of wheelchair. The brackets in this picture,
right and
left may look different from the ones on your wheelchair.
F
Please make sure that the brackets are tightly secured on the chair befo-
re each use. Do not use the max-e if the screws are loose. In such case
contact your dealer immediately.
2.2
Battery pack
Underneath your wheelchair's seat there is a bag attached for the battery
pack. You slip the battery pack into the bag...
...and secure it with a Velcro strap.
8
max-e
6.2
Exchange the fuses of the battery pack
On the battery pack there is a drawer containing
2 fuses of 40 A each.
If the lower fuse
is burnt out, echange it with the extra upper fuse aus.
If you need to exchange a fuse, put a pen into the opening
on the side of
the battery pack. This unlocks the drawer so it can be pulled out.
On curbs etc. a maximum current of almost 30 A is reached.
F
Only use fuses of 40 A.
25
max-e
Manual Handling Solutions 58, Paige Close, Watlington, Kings Lynn, Norfolk PE33 0TQ UK
Tel 0044 1553 811977 Fax 0044 1553 811004 sales@manualhandlingsolutions.co.uk www.manualhandlingsolutions.com