AAVARA PCE122 User Manual - page 5
5
Chapter 2
Installation
One Sender to One Receiver/HDTV configuration:
1 Connect HDMI cable between HDMI output port of video source and HDMI input port of PCE122 Sender.
2 Connect one 75 Ohm RG6U Coax cable between Coax 1 or Coax 2 output port of PCE122 Sender and
Coax in input port of PCE122 Receiver.
3 Connect the HDMI cable between input port of HDTV/display and the HDMI output port of PCE122
Receiver.
4 Connect the included 5V DC power supplies to PCE122 Sender and Receiver.
5 Power on the HDTV Display and PCE122 Receiver, then Video Source and PCE122 Sender.
One Sender to Multiple Receivers/HDTVs configuration:
1 Connect HDMI cable between HDMI output port of video source and HDMI input port of PCE122 Sender.
2 Connect one 75 Ohm RG6U Coax cable between Coax 1 output port of PCE122 Sender and Coax in
input port of Receiver 1.
3 Splitter mode: Connect one 75 Ohm RG6U Coax cable between Coax 2 output port of PCE122 Sender
and Coax in input port of Receiver 2.
4 Cascade mode: Connect one 75 Ohm RG6U Coax cable between the Coax cascade output port of
Receiver 1 and Coax in input port of Receiver 3.
5 Repeat Step 4 to connect all Receivers with Coax cables in Cascade mode.
6 Connect the HDMI cables between input port of each HDTV display and the HDMI output port of each
Receiver.
7 Connect the included 5V DC power supplies to all Sender and Receivers.
8 Power on the HDTV displays and PCE122 Receivers, then video source and PCE122 Sender.
Please refer the following diagram: