AAXA Technologies P300 User Manual - Chapter 4
Technical Details
39
Chapter 4
IMAGE IS BLURRED
Possible Causes
Solution
The Projector is not in focus
Adjust the focus with the focus adjustment dial
until the image comes into focus
The Projector is offset from plane / angle of
operation
Move the projector so that it is both 180 degrees
and on an evern plane with the screen.
No Sync, No Signal
Troubleshooting
1. Be sure to setup the computer to enable a video signal output. On some
laptops this is done by pressing and holding Function F5 key. If using the
P300 as an external monitor on Windows based systems, this can be done
by selecting “extend my desktop to this monitor”. The native resolution of
the P300 projector is 1280x800. Depending on the video driver different
resolutions may need to be selected for proper output.
Keystone Adjustments FAQ
38
How to Correct Keystone
•
If the image looks trapezoidal
with the base larger (as pictured
right), press the bottom button on
the directional pad on the top of
the P300 until the keystone effect
corrects and the picture turns into
a square projection.
•
If the image looks trapezoidal with
the top larger (as pictured right),
press the top button on the direc-
tional pad on the top of the P300
until the keystone effect corrects
and the picture turns into a square
projection.