AAxeon FCU-2802SC User manual

Manual is about: 10/100/1000Base-T to 1000Base-SX/LX Gigabit Ethernet Media Converter

Summary of FCU-2802SC

  • Page 1

    10/100/1000base-t to 1000base-sx/lx gigabit ethernet media converter user’s manual.

  • Page 2

    Trademarks copyright © aaxeon technologies 2010 contents subject to revision without prior notice. Aaxeon is a registered trademark of aaxeon technologies. The information in this manual is subject to change without notice. All other trademarks belongs to their respective owners. Disclaimer aaxeon t...

  • Page 3

    Weee warning to avoid the potential effects on the environment and human health as a result of the presence of hazardous substances in electrical and electronic equipment, end users of electrical and electronic equipment should understand the meaning of the crossed-out wheeled bin symbol. Do not dis...

  • Page 4

    6 7 1. Product features ● complies with ieee 802.3 10base-t, ieee 802.3u 100base-tx, ieee 802.3ab 1000base-t, ieee 802.3z 1000base-sx/lx ethernet standard ● bridge mode media converter with tp port supports 10/100/1000base-t and auto-mdi / mdix ● auto-negotiation for 10/100/1000base-t; half-duplex o...

  • Page 5

    8 9 3. Product outlook overview real panel top panel front panel bottom 5v dc figure 1: multi-mode/single-mode duplex model real panel top panel front panel bottom 5v dc figure 2: sfp model.

  • Page 6

    10 11 real panel top panel bottom 5v dc front panel figure 3: wdm (single-strand fiber) model left view the front panel of the gigabit ethernet media converter consists of one 1000base-sx / 1000base-lx / mini-gbic sfp / 1000base- lx wdm ports and one auto-sensing 10/100/1000mbps ethernet rj-45 port,...

  • Page 7

    12 13 rear view the rear panel of the gigabit ethernet media converter indicates one dc jack, which accepts input power with 5v dc 2a. 5v dc figure 7: one dc jack for dc power input. Note the device is a power-required device, it means, it will not work till it is powered. If your networks should be...

  • Page 8

    14 15 if the connection breaks, the fcu-280x link loss forwards to the switch/hub that generates a trap to the management station. The administrator can then determine the source of the issue. Media converter management station switch/hub w/snmp management station media converter switch/hub w/snmp t...

  • Page 9

    16 17 5. Installing the converter stand-alone installation to install a fcu-280x stand-alone, on a desktop or shelf, simply follow the steps below: step 1: turn off the power of the device/station on the network to which the fcu-280x will be attached. Step 2: ensure that there is no activity in the ...

  • Page 10

    18 19 6. Duplex mode support the fcu-280x is one-channel media conversion between 10/100/1000base-t and 1000base-sx/lx. The 10/100/1000base-t port can work under auto-negotiation mode. However, the 1000base-sx/lx fi ber port only works under forced 1000mbps full duplex mode. 7. Led indication led co...

  • Page 11

    20 21 8. Cable connection parameter the wiring details are as below: cables: standard fiber type cable specifi cation 1000base-sx (850nm) multi-mode 50/125μm or 62.5/125μm 1000base-lx (1300nm) multi-mode 50/125μm or 62.5/125μm single-mode 9/125μm wiring distances: standard fiber diameter (micron) mo...

  • Page 12

    22 23 cable 10/100/1000base-t: 1000base-t-2-pair utp cat. 5/5e/6, up to 100m 1000base-sx : 50/125μm or 62.5/125μm multi-mode fi ber optic cable, up to 220/550m (sc) 1000base-lx : 9/125μm single-mode fi ber optic cable 9/125μm single-mode fi ber optic cable, up to 10/15/20/30/40/50/60/70/120km (vary ...