AAxeon FCU-3002SX User Manual
PN: 6304X3002100XXX
Trademarks
Contents subject to revision without prior notice.
All trademarks remain the property of their owners.
Copyright Statement
This publication may not be reproduced as a whole or in
part, in any way whatsoever unless prior consent has been
obtained from owner.
FCC Warning
The OPTOLINX Gigabit Media Converter has been tested
and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These
standards are designed to provide reasonable protection
against harmful interference when this device is operated
in a commercial environment. This device generate, use,
and can radiate radio frequency energy and may cause
harmful interference to radio communications unless
installed in accordance with this User’s Guide. Operation
of this device in a residential area is likely to cause
harmful interference in which cases the user is
responsible for taking appropriate remedial action at
his/her own expense.
CE Mark Warning
This is class A products. In a domestic environment this
product may cause radio interference in which case the
user will need to consider adequate preventative
methods.
1. Checklist
The carton should contain the following items:
-
OPTOLINX Gigabit Media Converter
-
AC-DC Power Adapter
-
User’s guide
Please notify your sales representative immediately if any
items are missing or damaged.
2. Overview
The OPTOLINX Gigabit Media Converter is designed to
meet the massive needs for Gigabit network deployment.
This solution allows users to extend a copper based
Gigabit network via fiber cable to a maximum distance up
to 30KM.
The OPTOLINX Gigabit Media Converter is fully compliant
with IEEE802.3z & 802.3ab standards. It can be installed
into a FCU-RACK Converter Chassis. The installation &
operation procedures are simple & straightforward.
Operation status can be locally monitored through a set of
Diagnostic LED located in the front panel.
Features
-
1000Base-T to 1000BASE-SX/LX Converter
-
Standard : IEEE 802.3z & 802.3ab
-
Interface: 1 * RJ-45 connector
1 * SC Duplex connector or
1 * SC Simplex connector (W2 type)
-
MDI/MDIX Auto-Crossover supported
-
LED: Power , FDX , TP Link, FO Link ,
TP ACT, FO ACT
-
Plug-and-Play installation
-
Supports Link Alarm
-
Supports Jumbo Frame (64-9216 Byte)
-
Supports Voltage Monitor
3. Installation
•
Attach fiber cable from the OPTOLINX Gigabit Media
Converter to the fiber network. The fiber connections
must be matched – transmit socket to receive socket.
•
Attach a UTP cable from the 1000BASE-T network to
the RJ-45 port on the OPTOLINX Gigabit Media
Converter
•
Connect the power adapter to the OPTOLINX Gigabit
Media Converter and check that the Power LED lights
up. The TX Link and FX Link LEDs will light up when all
the cable connections are satisfactory.
•
Dip-switch select :
Default is set to OFF from PIN 1 to PIN 4
Pin 1 Off/On Always OFF -
Pin 2 Off/On Always OFF -
Pin 3 Off/On FX Force Mode FX Auto-Negotiation
Pin 4 Off/On Link Alarm Disable Link Alarm Enable
Link
ACT
FO TP
FDX PWR
5VDC IN
TX RX
Fig. 1 Gigabit Ethernet Converter Front Panel
Fig. 2 Gigabit Ethernet Converter Rear Panel
ON
OFF