AB IPBox 900hd User Manual - page 20
19
10.4. DVB-S Satellite Configuration
The Satellite Configuration menu will appear by pressing EXIT button after adjusting the Local Time when first
installation. Empty list of satellites appears. Press YELLOW button (Add satellite) to enter Satellite
configuration menu.
10.4.1 Setting of LNB parameters
Set up LNB parameters by pressing LEFT/ RIGHT button or OK button as your LNB and dish aimed. You can
see whole selectable values of each item by pressing OK button. You will see the Signal indicator as yellow
and green if all values are set correctly.
SAT Name
Name of satellite
LNB Type
Type of LNB (most common “Universal”)
Local Frequency
Local frequency (do not change the value if you do not use a special type of tuner! )
TP Frequency
Frequency of TP – setting of control TP of corresponding satellite
LNB Power
Power of LNB (must beset “ON” when using standard connection)
22kHz
Switching On/Off of 22kHz impuls
Toneburst
To control some alder typesof switches
DiSEqC Parameter
DiSEqC 1.0 and 1.1 contrpl up to 4 LNB
Uncomitted switch
Controlling of the second level of multilevel DiSEqC switches
DiSEqC Repeats
Repeating of DiSEqC commands (when using long cables for antenna)
Swap Commands
Delay of commands (when using long cables for antenna)
Sequence Repeat
Repeating of sequence