AB Quality PowerFlex 700S Quick Start Manual

Quick Start

PowerFlex

®

 700S Drive

Introduction

This document is designed to guide you through the basic steps needed to 

install, start-up and program the PowerFlex 700S Drive. The information 

provided does not replace the user manual and is intended for qualified 

personnel only. For detailed PowerFlex 700S information refer to the 

following: 

Precautions

Class 1 LED Product

General Precautions

Title

Publication

Available...

PowerFlex 700S User Manual

20D-UM001

www.theautomationbookstore

.com

PowerFlex 700S Reference Manual, Vol. 2 PFlex-RM-002

PowerFlex 700S Firmware Release Notes 20D-RN004

!

ATTENTION:  Hazard of permanent eye damage exists when 

using optical transmission equipment. This product emits intense 

light and invisible radiation. Do not look into module ports or 

fiber optic cable connectors.

!

ATTENTION:  This drive contains ESD (Electrostatic 

Discharge) sensitive parts and assemblies. Static control 

precautions are required when installing, testing, servicing or 

repairing this assembly. Component damage may result if ESD 

control procedures are not followed. If you are not familiar with 

static control procedures, reference A-B publication 8000-4.5.2, 

“Guarding Against Electrostatic Damage” or any other 

applicable ESD protection handbook.

!

ATTENTION:  An incorrectly applied or installed drive can 

result in component damage or a reduction in product life. 

Wiring or application errors such as under sizing the motor, 

incorrect or inadequate AC supply, or excessive surrounding air 

temperatures may result in malfunction of the system.

!

ATTENTION:  Only qualified personnel familiar with the 

PowerFlex 700S Drive and associated machinery should plan or 

implement the installation, start-up and subsequent maintenance 

of the system. Failure to comply may result in personal injury 

and/or equipment damage.