Hep hep hep hep hepa-aire por a-aire por a-aire por a-aire por a-aire port tt ttable air scrubber able air scrubber able air scrubber able air scrubber able air scrubber m m m m model p odel p odel p odel p odel pas1200 as1200 as1200 as1200 as1200 instruction manual instruction manual instruction ma...
1 ¼ » the hepa-aire ® ® ® ® ® portable air scrubber model pas1200 1. First stage 1" coarse/particulate pre-filter (p/n f621) 2. Second stage 2" pleated pre-filter (p/n h502) 3. Optional third stage 2" high capacity carbon filter (p/n vl1002). 4. Final stage 99.97% hepa filter (p/n h610c-99) 5. Motor...
2 hepa-aire ® ® ® ® ® portable air scrubber model: pas1200 instruction manual © abatement technologies 2003 all rights reserved. No reproduction of any portion of this work is permitted without the express written permission of abatement technologies, inc. Read and save these instructions! Note: 1. ...
3 • the first-stage 1"-deep, coarse particulate pre-filter (f621) is designed to capture particles 100 microns or larger. • the second-stage 2"-deep, pleated pre-filter (h502) is designed to capture particles 10 microns or larger. • each hepa filter (h610c-99) is tested & certified to capture at lea...
4 3. Select a safety factor (sf). Most users build-in between 10% (sf = 1.1) and 25% (sf = 1.25), or more. If you don’t wish to use a sf, proceed to step 4. 4. Calculate the minimum total airflow required (total cfm), as follows: total cfm = (v x ach x sf) ÷ 60. 5. # units required = total cfm ÷ cfm...
5 5. The pas1200 should be connected to a three-prong, properly grounded electrical outlet equipped with a ground fault circuit interrupt (gfci) device. A gfci is an electrical safety device that will trip the circuit and stop the flow of electricity if leakage of current is detected. Important note...
6 warning: abatement technologies air filtration systems are not intrinsically safe for use in hazardous environments. Always consult a certified industrial hygienist before using them. Do not use this equipment in any atmosphere that is or may be immediately dangerous to life or health (idlh), comb...
7 as with any air filtration system, external airflow losses not attributable to the air filtration unit will reduce the airflow of the system. The following recommendations can minimize airflow losses created by external static resistance. 1. Always use the minimum length of ducting possible with t...
To start unit 1. Check to make sure that the speed control switch is in the “off” position. Plug power cord into a 120 volt ac, 60hz, 15 amp supply circuit. 2. Turn speed control switch clockwise past the click at the “high” setting to turn power “on”. 3. Set speed control switch to desired setting....
Filter change procedure to change the first stage filter: 1. With the unit operating, pull up on the door latch and open the pre-filter access door. 2. Remove the first stage filter and replace it with a new one. 3. Close the door and lock it in position by pushing down on the latch. Make sure the d...
Pas1200 specifications note: specifications subject to change without notice. Airflow ratings (pas1200 is a variable speed unit) note: airflow ratings estimates are based on factory and independent testing @ 120 vac with an air straightener and a traverse of readings taken with a computing vane-anem...
Troubleshooting guide 11 m e l b o r p e s u a c e l b i s s o p n o i t u l o s e h t n e h w e s n o p s e r o n . " n o " d e n r u t s i r e w o p . D e g g u l p n u d r o c r e w o p - . D r o c r e w o p e v i t c e f e d - . R e k a e r b t i u c r i c d e p p i r t - t i u c r i c t l u a f...
12 warning: keep electrical components dry as their exposure to liquids poses a safety hazard and can damage components. Certification of room air filtration units the abatement technologies room air filtration units have been tested by intertek testing services (its) and are etl and etlc (canada) l...
13.
14.
15.
