1. DL manuals
  2. ABB
  3. Switch
  4. ESP630 A2
  5. Product manual

ABB ESP630 A2 Product manual

Manual is about: Ethernet Service Platform. ESP630 series

Summary of ESP630 A2

  • Page 1

    Esp630 from abb ethernet service platform product manual esp630 abb esp630 abb esp630

  • Page 2

    Product manual esp630 copyright and confidentiality: copyright in this document vests in abb ltd. This document contains confidential information which is the property of abb. It must be held in confidence by the recipient and may not be used for any purposes except those specifically authorised by ...

  • Page 3: Conventions

    Esp630 product manual 1khw02104 /ed01a page 3 of 29 abb conventions the following conventions were adopted along this manual, in order to better understanding: hyperlink – indicates an address on internet or an e-mail address. Command or button - when a command, button or software’s menu is referred...

  • Page 4

    Esp630 product manual 1khw002104 / ed01a page 4 of 29 abb.

  • Page 5: Table of Contents

    Esp630 product manual 1khw02104 /ed01a page 5 of 29 abb table of contents 1 introduction ........................................................................................ 6 1.1 overview ..............................................................................................................

  • Page 6: Introduction

    Esp630 product manual 1khw02104 /ed01a page 6 of 29 abb 1 introduction 1.1 overview the esp630 3x24ax is a member of the abb switch esp630 family. The esp630 is a family of metro ethernet switches with l2 and l3 wire-speed commutation capability, mpls features, which allow its utilization as a label...

  • Page 7: 1.2

    Esp630 product manual 1khw002104 / ed01a page 7 of 29 abb fig. 1-2. Overview of the esp630 a3 1.2 front panel description the front panel of the esp630 a2 contains 24 10base-t/100base-tx ports, 4 10/100/1000base-t /sfp combo ports, rs-232 console port, an alarm port and two buttons for changing stac...

  • Page 8

    Esp630 product manual 1khw002104 / ed01a page 8 of 29 abb 1.2.1 system status leds the system status leds on the front panel can be used to monitor system activity. Following figure shows where the leds are located and the table below indicates the system status according to each leds condition. Fig...

  • Page 9

    Esp630 product manual 1khw002104 / ed01a page 9 of 29 abb fig. 1-6. Ports leds location table 1-2. Ports leds 1.2.3 console and alarm ports the switch contains two db9 connectors on its front panel. The upper connector is the alarm port and the lower is the console port. The pin-out of both console ...

  • Page 10

    Esp630 product manual 1khw002104 / ed01a page 10 of 29 abb fig. 1-7. Console and alarms ports pins order the alarm port contains 3 alarm inputs and 1 alarm output. The inputs accept voltage differences from 8v to 60v (indicating alarm on) or less than 8v (indicating alarm off). The alarm output work...

  • Page 11: 1.3

    Esp630 product manual 1khw002104 / ed01a page 11 of 29 abb table 1-4. Console port pins assignments: 1.2.4 slave/master and stack/uplink buttons esp630 contains two buttons to control stacking. When pressed, the stack/uplink button makes the switch operate in standalone mode, allowing the ports 27 a...

  • Page 12

    Esp630 product manual 1khw002104 / ed01a page 12 of 29 abb fig. 1-9. Esp630 a2 rear panel the ac/dc power inputs accept any supply voltage in the range from 100~240 vac at 50~60 hz and 36~72vdc. Each connector supplies one power unit. The use of a redundant power unit is optional. The switch is able...

  • Page 13: Switch Installation

    Esp630 product manual 1khw002104 / ed01a page 13 of 29 abb 2 switch installation 2.1 package contents • one stackable esp630 3x24ax; • two mounting brackets already attached to the switch; • one ac power cord. 2.2 installation guidelines before you choose a location to install the switch, make sure ...

  • Page 14: 2.4

    Esp630 product manual 1khw002104 / ed01a page 14 of 29 abb 2.4 installing the switch in a rack the switch can be installed in a 19" rack. The brackets used to fix the device already come attached to the switch. To install the switch in a rack, use the following procedure and refer to the figure belo...

  • Page 15: 2.6

    Esp630 product manual 1khw02104 /ed01a page 15 of 29 abb if dc power is used, the power cable should be cut close to the ac sockets connection plug and con nected in a way that the socket central pin corresponds to ground protection and the other 2 pins supply the power, as seen in the next figure. ...

  • Page 16: Making Connections

    Esp630 product manual 1khw02104 /ed01a page 16 of 29 abb 3 making connections 3.1 connecting devices through rj-45 ports the esp630 can be connected to 10, 100 or 1000 mbps devices. Its ports accept automatic mdi/mdi-x configuration, so either crosses or straight cables can be used. Use unshielded t...

  • Page 17

    Esp630 product manual 1khw002104 / ed01a page 17 of 29 abb 1. Insert the sfp transceiver into one of the four switch module bays. There’s only one orientation that the module can be plugged. The optical connector should face outward and the slot connector, down. 2. Slide the module into the slot and...

  • Page 18: 3.3.

    Esp630 product manual 1khw02104 /ed01a page 18 of 29 abb 3.3. Connecting the switch in a stack configuration esp630 supports two stacking topology configurations, the line and the ring topologies. In line-topology, there’s one cable connecting each switch to its neighbors. In ring-topology, a redund...

  • Page 19: A.1

    Esp630 product manual 1khw002104 / ed01a page 19 of 29 abb 4 appendix a. Technical specifications a.1 physical and environmental table a-1. Physical and environmental specifications: esp630 a2: 61.0 w atts maximum esp630 a3: 75.0 w atts maximum (-10 to 65 degrees c elsius) (-40 to 70 degrees c elsiu...

  • Page 20: Appendix B. Sfp Modules

    Esp630 product manual 1khw02104 /ed01a page 20 of 29 abb 5 appendix b. Sfp modules types of sfp modules that esp630 family uses: b.1 unidirectional modules features: • duplex lc connector; • hot pluggable; • supply voltage 3.3volts; • case operating temperature 0-70 degrees celsius; • output eye com...

  • Page 21

    Esp630 product manual 1khw002104 / ed01a page 21 of 29 abb table b-3. 1000base-lx+ singlemode 30km table b-4. 1000base-lh singlemode 70km table b-5. 1000base-lz singlemode 110km.

  • Page 22: B.2

    Esp630 product manual 1khw002104 / ed01a page 22 of 29 abb b.2 bidirectional modules features: • simplex lc connector; • hot pluggable; • supply voltage 3.3volts; • case operating temperature 0-70 degrees celsius; • output eye compliant with ieee802.3z; • compliant with sff8472 diagnostic monitoring...

  • Page 23

    Esp630 product manual 1khw002104 / ed01a page 23 of 29 abb table b-8. 1000basebx60-u singlemode 60km table b-9. 1000basebx60-d singlemode 60km.

  • Page 24: B.3

    Esp630 product manual 1khw002104 / ed01a page 24 of 29 abb b.3 cwdm modules features: • duplex lc connector; • hot pluggable; • supply voltage 3.3volts; • case operating temperature 0-70 degrees celsius; • output eye compliant with ieee802.3z; • compliant with sff8472 diagnostic monitoring interface...

  • Page 25

    Esp630 product manual 1khw002104 / ed01a page 25 of 29 abb table b-11. 1550nm-19db margin table b-12. 1310nm-23db margin table b-13. 1550nm-23db margin table b-14. 1310nm-27db margin.

  • Page 26

    Esp630 product manual 1khw002104 / ed01a page 26 of 29 abb table b-15. 1550nm-27db margin table b-16. 1310nm-30db margin table b-17. 1550nm-30db margin.

  • Page 27

    Esp630 product manual 1khw002104 / ed01a page 27 of 29 abb.

  • Page 28: 6.1

    Esp630 product manual 1khw02104 /ed01a page 28 of 29 abb 6 references and abbreviations 6.1 references itu-t g.703 physical/electrical characteristics of hierarchical digital interfaces g.707 network node interface for the synchronous digital hierarchy (sdh) g.783 characteristics of synchronous digi...

  • Page 29

    Abb switzerland ltd power systems brown boveri strasse 6 ch-5400 baden / switzerland phone +41 58 589 37 35 or +41 844 845 845 (call center) fax +41 58 585 16 82 e-mail utility.Communication@ch.Abb.Com www.Abb.Com/utilitycommunications.