1. DL manuals
  2. ABB
  3. Computer Hardware
  4. SROUT
  5. Technical Reference Manual

ABB SROUT Technical Reference Manual

Manual is about: Router Option Card for Lon Star Coupler RER 111

Summary of SROUT

  • Page 1

    Abb automation srout router option card for lon star coupler rer 111 technical reference manual.

  • Page 2

    (empty).

  • Page 3

    Abb automation 3 srout issued: 09.12.1997 version: b2/24.2.2000 checked: m.K. Approved: t.S. We reserve the right to change data without prior notice. Router option card for lon star coupler rer 111 technical reference manual contents: 1. Introduction ...................................................

  • Page 4: 1. Introduction

    4 abb automation 1mrs 750109-mum router option card for lon star coupler rer 111 srout 1. Introduction the router option card is designed to be used within the lon star coupler rer 111. This device is not a "stand-alone" device. The router option card connects two different communication channels an...

  • Page 5

    1mrs 750109-mum router option card for lon star coupler rer 111 srout abb automation 5 )lj 6\vwhpvwuxfwxuhzkhqwkhileuhrswlflqwhuidfhlvxvhgwrglylghdodujh qhwzrunlqwrwzrvxeqhwv the router option card can also be used as a network repeater to increase the number of lon star couplers in the network. Wit...

  • Page 6

    6 abb automation 1mrs 750109-mum router option card for lon star coupler rer 111 srout )lj 5rxwhurswlrqfdugdvduhshdwhuehwzhhqwzrjurxsvri/216wdu &rxsohuv sfib103 bb sfib103 bb sfib103 bb sfib103 bb sfib103 bb sfib103 bb sfib103 bb sfib103 bb sfib103 bb microscada fibre-optic connection fibre-optic co...

  • Page 7: 2. Functions

    1mrs 750109-mum router option card for lon star coupler rer 111 srout abb automation 7 2. Functions the router option card has one 9-pin d-type connector for the twisted pair interface and one fibre-optic transceiver pair. There are two transceiver modules available for the twisted pair interface, e...

  • Page 8

    8 abb automation 1mrs 750109-mum router option card for lon star coupler rer 111 srout a message received from the twisted pair interface is passed on to the open-collector bus on the mother board, through the rtr-10 core module. A message received from the open collector bus is sent to the twisted ...

  • Page 9

    1mrs 750109-mum router option card for lon star coupler rer 111 srout abb automation 9 3. Mechanical and electrical design 3.1. Block diagram )lj %orfngldjudpriwkhurxwhurswlrqfdug 3.2. Mechanical structure the router option card is built on a printed circuit board (pcb) of size 100 mm x 160 mm. The ...

  • Page 10: 4. Interfaces

    10 abb automation 1mrs 750109-mum router option card for lon star coupler rer 111 srout 4. Interfaces 4.1. General the router option card has five separate interfaces: - a 64-pin e1 card connector for the connection to the mother board of the rer 111 unit - a fibre-optic transceiver pair - a 9-pin d...

  • Page 11

    1mrs 750109-mum router option card for lon star coupler rer 111 srout abb automation 11 4.3. Fibre-optic interface for more information regarding fibre-optic cables and the fibre-optic connection of option cards, refer to the rer 111 manual 1mrs750104-mum, chapter 6.2. 4.4. Service switch the servic...

  • Page 12

    12 abb automation 1mrs 750109-mum router option card for lon star coupler rer 111 srout 5. Installation, configuration and programming 5.1. Installation as the router option card is not intended for "stand-alone" use, it has to be installed in the rer 111 unit. It can be placed in any of the 9 slots...

  • Page 13

    1mrs 750109-mum router option card for lon star coupler rer 111 srout abb automation 13 the figure below shows the required jumper settings of jumper groups s1, s2, s3 and s4 for each transceiver mode and the corresponding transceiver id. Router side a can be set to be a tp/xf-78 interface, i.E. 78 ...

  • Page 14

    14 abb automation 1mrs 750109-mum router option card for lon star coupler rer 111 srout )lj -xpshujurxs6irufrqqhfwlqjwkhileuhrswlflqwhuidfhwrurxwhu vlgh% 5.2.2. Default settings: 5.3. Programming of the router option card there are two neuron chips on the rtr-10 core module. These two neuron chips s...

  • Page 15

    1mrs 750109-mum router option card for lon star coupler rer 111 srout abb automation 15 once the router option card has been programmed, the fibre-optic mode can be configured for router side a, if required. To enable this, the communication parameters must be set from router side b. In the fibre-op...

  • Page 16

    16 abb automation 1mrs 750109-mum router option card for lon star coupler rer 111 srout the same subnet, the message will not be passed on to subnet 2. But if node x in subnet 1 sends a message to node z in subnet 2, the message will naturally be passed on to subnet 2). This is done by changing the ...

  • Page 17

    1mrs 750109-mum router option card for lon star coupler rer 111 srout abb automation 17 comm_type: 6lqjohhqghg comm_pin_dir: 'luhfwprgh±vlqjohhqghg channel type: fxvwrp (behind the 6hohfw&kdqqho7\sh button) comm_clock: (behind the %lw5dwh button) input_clock: (behind the %lw5dwh button) 3uhvvwkh5rxw...

  • Page 18: Technical Data

    18 abb automation 1mrs 750109-mum router option card for lon star coupler rer 111 srout 6. Technical data interfaces transformer-isolated twisted pair interface 9-pin d-type female connector communication speed 78 kb/s or 1.25 mb/s max. Number of router option cards in one rer 111 unit 2 fibre-optic...

  • Page 19: Maintenance and Service

    1mrs 750109-mum router option card for lon star coupler rer 111 srout abb automation 19 7. Maintenance and service 7.1. Self-diagnostics 7.1.1. Fibre-optic receiver led the receiver led flashes when a message is being received from the fibre-optic channel. If the led is continuously lit, the channel...

  • Page 21: Appendix A

    1mrs 750109-mum router option card for lon star coupler rer 111 srout abb automation 21 appendix a default values of communication parameters and routing tables for the router option card, sides a and b. These default values are set during manufacturing and they are stored in eeprom memory of the ne...

  • Page 22

    22 abb automation 1mrs 750109-mum router option card for lon star coupler rer 111 srout when the fibre-optic interface is connected to router side a, these values must be used for router option card side a, too. Table 3: configuration structure fields and values programmed for router option card sid...

  • Page 24

    Abb substation automation oy p.O. Box 699 fin-65101 vaasa finland tel. +358 10 224 000 fax. +358 10 224 1094 www.Abb.Fi 1 m r s 7 5 0 109 -m u m e n 05. 200 0