Abbott FreeStryle Lite Owner's Booklet - page 16
25
26
4.
Confirm System Check Screen.
•
This display appears when you turn on the meter. Do not use the meter if
the display check screen does not exactly match the example. Contact
Customer Care.
•
See The FreeStyle Lite Meter and How It Works section for more information.
•
If the system check screen does not appear, go to Troubleshooting section.
5.
Apply and hold control solution to 1 sample area of the test strip until:
•
You see short lines moving clockwise on the display or
•
You hear a beep
This indicates the test strip obtained enough control solution and the meter is
processing. If the test does not start after applying the control solution, go to
Troubleshooting section.
IMPORTANT: If a short line does not appear after 5 seconds, the
sample may be too small. Do not add control solution to both sides
of the strip. The test strips are for single use only. Do not reuse test
strips. Dispose of used test strips.
(Example only)
6.
View result.
The result appears on the display when the test is complete.
7.
Compare the control solution result to the range printed on the test strip vial.
The result should fall within the range.
Note: If you see an “Er1, Er2, Er3 or Er4” on the display, it is an error code. Go to
Error Codes section.
8.
Press and hold
c
for 2 seconds until appears on the display to mark the
result as a control solution result. To unmark a control solution test result, press
and hold
c
for 2 seconds. A value with the indicates you have marked
this reading as a control solution test.
9.
Remove the test strip to turn meter off.
www.AbbottDiabetesCare.com
ART22315-101_rev-B.indd 25-26
9/11/14 12:07 PM