1 “when you need more than staples.” toll free: 800-658-8788 fax: 801-927-3037 info@abcoffice.Com ideal cutters model 4850 (18-3/4”) model 4850-90 (18-3/4”) model 5250 (20-1/2”) model 6550 (25-1/2”) model 6550-90 (25-1/2”).
2 safety rules • ensure that at no time more than one person is working at the machine. • leave the key for the safety lock with the person responsible for the cutting machine. • power operated cutting machines must be operated only by trained and reliable personnel. Part of the training is to becom...
3 the entire machine is dispatched in one package, but the stand has been dismounted from the machine. The tool box contains: - a set of tools for service and maintenance, - the mounting hardware for the stand, - the back gauge crank (#3) with a mounting screw, - two keys for safety lock. • place ma...
4 the key can be removed to prevent unauthorized use. To activate the machine, turn the key 45º to the right. • re-set button (#14) before the knife can be activated on models ideal 4850, ideal 5250 and ideal 6550, the re- set button has to be pressed to re -establish the “ready to cut” status of th...
5 under the viewing window (#16) the measuring scale rotates in accordance with the back gauge movement. The exact measurement is to be read beneath the indicator. To avoid inaccuracies, the scale has to be read vertically from above. • optical cutting indicator with exception of the ideal 5250, all...
6 maintenance knife change precise cuts are only possible with a sharp knife. The knife should be changed as soon as the quality and the accuracy of a cut are not in accordance with the standards expected from this cutting machine. Should the knife jam in the paper pile or leave grooves in the paper...
7 ideal 6550-90: remove knife screws (b and c). Loosen knife holders and lower the knife downwards from the knife carrier (#19). Then, due to the length of the knife, a sideways movement between the knife guide plates is required for removal. H. Take out cutting stick (#2), turn, rotate or exchange ...
8 important – if the knife has been lowered by means of the cutting depth adjustment screw (#6) to compensate for a worn cutting stick , then this adjustment screw (#6) has to be turned back to its highest setting before the cutting stick (#5) is turned, rotated or exchanged. Then re -adjust screw (...
9 should the machine cut out during operation, check the overload switches (#11 and #12). If one of the buttons of the overload switches has popped out, it can be re -set after a short period. Should the overload switch pop out again and cannot be re -set even after a few minutes, please contact you...
