AbelCine ProVFM Owner's Manual - page 5
of
8
Slide the top half of the mount
into the dovetail of the base, and
use the thumb screw to hold the
mount in the desired front-back
position. Slide your Sony or
Panasonic viewfi nder onto the
front plate and tighten the
thumb nut to secure it in place.
Adjust the viewfi nder left and
right as necessary.
Attach the signal box to the right
side of the Berkey plate using the
supplied screws and wrench.
If the viewfi nder mount is
attached farther back on the
Berkey plate, then the signal box
may also be attached farther back
as appropriate.
Connect the cable from the
viewfi nder to the front of the signal
box, labeled SO VF or PN VF.