AbiSee Eye-Pal SOLO LV Quick Reference

1

Quick Reference For Eye-Pal Solo  

SOLO LV allows you to read printed text and magnify small objects. There are 

three ways Solo LV can be used to read printed material. 

Front Panel Buttons – conveniently placed 

Motion Activated – the no button solution  

Keypad – controls at your finger tips 

Front Panel: 

Power - the green square button all the way to the right is used to turn the 

device on as well as off.  

Pause/Resume reading - the white circle button on the left side of the knob on 

the front panel allows you to pause and resume reading. If this circle button is 

held down for 3 seconds it will enable/disable the use of hand motions. 

Read Previous Sentence - the red square button all the way to the left is used 

to read the previous sentence. Again this button may be pressed as many times as 

you need to go back to a certain sentence. If this red button is held down for 5 

seconds it will restart the software. 

Reading Speed - to the right of the knob are two white square buttons. These 

square buttons are lined up vertically one on top of the other. The top button will 

increase the reading speed, while the bottom button will decrease the reading 

speed. 

Volume - may be changed by turning the knob in the middle of the front panel of 

the device.  

Restarting - if device freezes press the red button for 5 seconds. You will hear 

the device say “restarting”. 

Motion Activated Controls:

 (By default this is disabled) 

To enable motion activated controls press the white circle on the front panel and 

hold down for 3 seconds. 

Pause/ Stop Reading - move your hand slowly above the printed material from 

left to right. 

Resume Reading - move your hand slowly above the printed material from left to 

right