ABLE Ap25 User Manual - page 6
line for descenders and a dot line above and below each character line. The number of characters
required to fill a dot line varies according to the printer, as follows:
0.20mm
0.33mm
0.4 lines/second
40 characters per line
Ap25-40
0.25mm
0.33mm
0.5 lines/second
32 characters per line
Ap25-32
0.33mm
0.33mm
0.7 lines/second
24 characters per line
Ap25-24
Horizontal
dot pitch
Vertical dot
pitch
Lines per second
Characters per line
Printer
The ASCII characters 32 to 255 (32 to 127 if using a backwards compatible 7 bit character set) are in
the printable range. Any character below character 32 is ignored unless it is one of the control codes
(section 5.7).
5.6 Graphics Printing
The product is programmed to take advantage of the graphics printing capability of the mechanisms.
Graphics are received as the least significant 6 bits of each byte. In this way the same number of
graphics bytes are required to terminate a line as the number of characters required to print a
complete line. The graphics mode is reset at the end of every dot line and hence the graphics
command,
as a succession of dot lines across the paper. The number of bytes required to fill a dot line for each
mechanism are the same as the number of characters required to fill a dot line. Large areas of solid
dots are not recommended as they may cause over heating and shorten the ribbon life. Heavy
graphics printing may also require a higher current power supply.
A typical graphics line for the Ap25 would be:
Control code
Data (24 bytes for the Ap25-24)
<00><00><01><02><03><04><05> etc.
5.7 Control Codes
9 character sets which may be selected for backwards compatibility. The default character set is the
8 bit IBM 224-character set.
Previous versions of the Ap24 family have been supplied programmed with 7 bit character sets, UK,
French, German, “Scandinavian”, Danish/Norwegian, Swedish, Japanese and Spanish character
variations (often to special order). The Ap25 contains all these variants, which are software selected
for backwards compatibility. 8 bit data is selected when using the 8 bit IBM character set, otherwise
the 8th data bit is ignored.
The structure of the command is as follows:
Country selection:
0
0
0
1
Spanish
1
1
1
0
Japanese
0
1
1
0
Swedish
1
0
1
0
Danish
0
0
1
0
Scandinavian
1
1
0
0
German
0
1
0
0
French
1
0
0
0
UK
0
0
0
0
Full 8 bit IBM (default)
B0
B1
B2
B3
Character set
(If buffer is not empty, print buffer contents and) Set print mode:.
Note: n is a byte of the form [ 0,0,0,0,B3,B2,B1,B0] (all except the lower 4 bits must be zero, to avoid
conflict with other ESCape codes).
Ap25 Users’ Guide Page 5 of 8