AbleNet iTalk2 Quick Start Manual
Select Level & Enter Record Mode
2
Press and Select
Play Messages
5
Record Messages
3
Exit Record Mode
4
Insert Battery and Turn On
1
Quickstart Guide:
iTalk2™ with Levels communicator
www.ablenetinc.com
Connect one 9-volt battery at the bottom of the device.
Rotate the Volume ON/OFF knob to turn the device on.
iTalk2 includes a detachable Mounting Base that must be
removed to access the battery door. Press the tab and slide
to remove the base.
Press and Hold the RECORD button until the RECORD
Light activates, then Release.
Select desired Level using the Level Switch on the side
of the device.
Press and Release the RECORD button to exit Record
Mode.
NOTE: This device has 4 minutes of total recording time. The
light will turn yellow and flash when only ten seconds of time
remain.
iTalk2 is now programmed and ready for use.
a. Press and Hold a switch top, begin speaking when
you hear a beep. Release when finished.
b. Repeat for second location.
c. Switch Level and repeat above steps to record
additional Levels.
RECORD Light will flash while recording.
On
Press and Release
a
b