AbleNet SuperTalker Quick Start Manual
Record Messages
4
Overlays and ideas at www.ablenetinc.com
Enter Record Mode
3
Powering SuperTalker
1
Quickstart Guide:
SuperTalker™ progressive communicator
Insert four AA batteries into the device as shown. Power
On/Off is located on the spine of the device.
Select Level and Grid
2
With the desired Overlay and Keyguard in place:
Select a LEVEL (1-8) and Grid (1, 2, 4, 8) using the
controls on the spine of the device.
NOTE: Be sure to match the Grid number to the Keyguard
and Overlay currently installed on the device.
For information on Overlays, Keyguards and Helpful Tips, see
reverse.
Press and Hold the RECORD button until the RECORD
Light activates, then Release.
Press and Hold the desired Message location, begin
speaking when you hear a beep. Release when finished.
Repeat for additional messages.
RECORD Light will flash while recording.
NOTE: Speak close to the microphone for loud, clear sound.
Exit Record Mode
5
Press and Release the RECORD button to exit Record
Mode.
NOTE: This device has 16 minutes of total recording time.
The RECORD Light will turn yellow when only two minutes
remain.
Adjust as-needed
Power
Press and Hold,
then Release
Press and Hold
while speaking
Press and
Release