Ablerex Buck 1000W User Manual - Caution!
15
Step4: If you would like to escape from battery over- and under- voltage setting, please
press
key to escape.
2.1.5 Battery Under-Voltage Limit Setting
In normal condition, it is not necessary to calibrate this setting as long as the battery voltage
selected is within window. For example, if the user selects 24V, the default under-voltage is
18V. In case the battery voltage desired is lower than this voltage, you may calibrate
battery voltage to be lower. The setting procedure is as below:
Caution!
In normal condition, it is not necessary to calibrate this setting. Before processing the
setting, make sure the battery voltage setting is done properly to avoid damaging battery
or load.
Step1: When entering into Battery Over-voltage setting, it shows the current battery
under-voltage.
Step2: In case of any other desired voltage, please press
key or
key to
choose the figure you prefer. The figure with blinking means the current place
you are. To change the figure at left-hand side, please press
key, on the
contrary, you may press
key to change the right-hand side.
Step3: After the battery under-voltage is selected, please press
key till “SAVE”
shown on the screen new parameter. If the “SAVE” extinguishes from the screen
and show “OVER” instead. It means the voltage selected is higher than the
battery’s over-voltage.
Step4: If you would like to escape from battery over- and under- voltage setting, please
press
key to escape.
2.1.6 Pulse Charge Setting
It is to set if the charger can be in pulse charge. Basically, the charger is set at Pulse
Charge setting as default. Setting procedure is as below: