M73-apo07-110 adsl router quick installation guide.
- 1 - parts names and functions rear view of the adsl router led indicator top view of adsl router (leds).
- 2 - led description power router power on/off indicator adsl_pwr adsl module power on/off indicator eth_lnk ethernet link indicator eth_act ethernet active indicator adsl_auto adsl auto connection indicator adsl_link adsl data link indicator adsl_err adsl link error indicator connectors on the rea...
- 3 - setting up the hardware environment connecting all cables to the network perform the following procedures to set up the adsl router. Step 1 connect the power adapter to the port labeled 5vdc on the rear panel of this device. Step 2 connect the ethernet cable. One pc – adsl router (direct conne...
- 4 - step 4 connect one end of rs-232 cable to any free com port in your system; connect the other end to “console” port on the rear panel of the adsl router. Powering on the adsl router step 1 connect the power adapter to your adsl router by plugging one end of the power supply into an appropriate...
- 5 - internet access router mode/ ip over atm (rfc1577) (1) run the “router.Exe” file saved in the configuration utility. (go to start ÆprogramÆ adsl router xx configuration utilityÆconfiguration utility.) (2) select a pc com port available on your computer used to connect to the adsl router’s “con...
- 6 - (8) click “ok” to go to “select config” menu. Or click “save as file” to save the settings for future use. Then click “next”. (9) click “configure” button. The configure utility will automatically setup the router for you. Expect a minor delay for configuration. Bridge mode/rfc1483 bridge (1) ...
- 7 - (6) enter vpi and vci numbers. Then click “ok”. (7) check “llc encapsulation” or “vc based route” or “vc based bridge”. (8) click “next” followed by “configure”. Configure utility will automatically setup the router for you. Expect a minor delay for the router configuration. (9) click “finish”...
