M73-apo02-560 u u s s b b a a d d s s l l m m o o d d e e m m q q u u i i c c k k i i n n s s t t a a l l l l a a t t i i o o n n g g u u i i d d e e.
Regulatory statements part15, class b this device complies with part 15 of fcc rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interface, and 2. This device must accept any interface received, including interface that may cause undesired operation. T...
Table of contents hardware installation ........................ 1 software installation ......................... 2 windows 98/98se/me................................ 2 windows 2000/xp ...................................... 4 pppoe and pppoa configuration ........... 10
Hardware installation p p r r e e c c a a u u t t i i o o n n before the installation, make sure the usb port exists in your computer and is enabled. Go to my computer Æ control panel Æ system. Open the device manager tab, check if the universal serial bus controller device is found. 1. You can conn...
Software installation as you perform the installation, have your windows disk at hand. You may need this disk to refresh or replace some windows software. Also, make sure you have the existing telephone network service and an isp (internet service provider) offered you adsl service. After the device...
5. Click next. 6. Insert the windows 98/98se cd, and then click ok. 7. Click finish. - 3 -.
8. Click yes to restart your computer. 9. At the welcome screen, click next. 10. Please refer to step 7 ~ step 13 in windows 2000/xp section to continue the installation. W w i i n n d d o o w w s s 2 2 0 0 0 0 0 0 / / x x p p 1. For windows 2000 applications, click next. - 4 -.
2. For windows 2000 applications, select recommended option, then click next . For windows xp applications, select advanced option, then click next. 3. Insert the supplied cdinto the cd-rom drive. Select cd-rom then click next. 4. For windows 2000 applications, in “driver files search results”, clic...
6. At the welcome screen, click next. 7. In “license agreement”, click yes. 8. In “read me”, click next. - 6 -.
9. In “driver components”, follow your internet service provider (isp) instructions to select the appropriate driver type from rfc1483, pppoa, or pppoe. You may also see an option to change the vpi/vci settings. Then click next.. ~ rfc1483 10. Select the appropriate framing setting given by your int...
11. This step is only for users who select rfc1483 in step 9: follow your internet service provider (isp) instructions to select from bridged or routed. If the isp did not mention about it, select bridged. Then click next. È in ”ip configuration“, refer to the information provided by your internet s...
12. Click finish. 13. In “rebooting machine”, select yes, i want to restart my computer now. Click ok to restart the computer. 14. For windows xp applications, click continue anyway to complete the installation. - 9 -.
P p p p p p o o e e a a n n d d p p p p p p o o a a c c o o n n f f i i g g u u r r a a t t i i o o n n after you have installed the appropriate driver, follow below steps to configure the connection. 1. Click either the desktop icon, or the dial-up networking icon to open the connect to window. 2. ...
