Abode APSM3001 User Manual - Using Your Steam Mop
9
Using your steam mop
Use the microfibre mop pads alone for cleaning sealed
hard floors.
Attach the carpet glider to help the steam mop head move
over carpeted surfaces smoothly.
Note: The steam mop head rests into the carpet glider and
does not click into place.
Release the cord by twisting the quick
release cord storage hook, and plug into a
mains socket.
Attach a microfibre pad by lifting the steam
mop and placing the mop head on to the
pad.
Turn the steam mop on by pressing the power button.
Wait 30 seconds for the water to heat up.
Your steam mop is now ready to use.
Note: It is normal for the steam mop to make noise during
operation.
Use on sealed hard floors and carpets only.
In the upright position, the mop will not steam.
Tilt the steam mop backwards, approximately 45°, and it will
begin to steam.
Note: When using the steam mop, do not leave it over a
particular area for more than 30 seconds. This could cause
damage to the floor. Test on an inconspicuous area before use.