Abode ASM2001 User Manual - Problem Solving
13
Problem Solving
PROBLEM
POSSIBLE PROBLEM
POSSIBLE SOLUTION
Trouble assembling
steam mop
1. Difficult to attach mop
head.
1. The main body of the product can be pushed down into
the nozzle of the mop head. Ensure the groove is aligned
correctly with the body. Refer to page 7 of the instruction
manual provided.
2. Difficult to assemble
handle.
2. Insert the tube provided into the tube with the handle
on the end. This should be pushed in enough so that there
is only a thin section of the black plastic visible. Once this
has been assembled, push it down into the slot on the
main body, located on the back of the steam mop until
secure. Refer to page 8 of the instruction manual
provided.
3. Difficult to attach mop
pad.
3. Lay the mop pad on the floor and lift the steam mop
head, placing onto the pad. Make sure the microfibre side
of the pad is on the floor and attach the mop to the other
side.
4. Difficult to attach
carpet glider.
4. Lift the mop and place the head into the side of the
carpet glider that has space for the mop head. The mop
head rests in the glider and does not click into place.
Filling/Emptying
water tank
1. Difficult to fill water
tank.
1. Ensure that the steam dial is in the “close” position.
Unscrew the cap on the water tank in an anticlockwise
direction and remove. Be careful not to lose this. Put
250ml of water into the filler cup provided and transfer
this into the water tank on the main body of the steam
mop. Replace the cap on the water tank and turn
clockwise to secure.
Note
: Do not use detergents in the
steam mop, this may cause damage.
2. Difficult to empty
water tank.
2. Unplug the steam mop. Unscrew the cap of the water
tank, turning anticlockwise and remove. Lift the steam
mop over a sink and carefully tip any contents of the tank
down the sink. Replace the cap onto the water tank.
Reduced steam/no
steam is coming out
1. Water tank may not be
filled.
1. Make sure the water tank is filled. Refer to page 8 of
the instruction manual provided.
2. The unit may not be
plugged in properly/the
fuse or breaker may not
be working.
2. Verify the unit is plugged into an approved electrical
outlet and that the fuse or breaker is functioning properly.
Ensure you have waited 60 seconds for the water to heat
up.
3. Steam dial is set to
“close”.
3. Check that the steam dial is set to “open”. Also, the
product needs to be tilted for use.