ABS MegaCam HS421X Easy Installation Manual - page 4
of
5
Easy Installation Guide for ABS MegaCam HS421X 6” Outdoor Housing (for 421M/4210 Network Camera)
©1990-2008 ABS Computer Technologies Inc. All Rights Reserved
4
Step 7:
Move the LAN cable underneath and to the side of the electrical board. Insert the 12V DC power
adaptor to electrical board connector marked “DC In”.
Note: Minimum requirement is 12V DC 1.5A adaptor (DC for both P/T IP cam and heater/fan)
Step 8:
Insert “power transmission cable” to the electric board connector marked “DC Out”.
Move LAN cable from center to side
Insert power adaptor to “DC in” connector
Power transmission
cable
Insert to “DC
Out” connector
Put cables in order