© 2011 abstract data ltd. Http://www.Abstractdata.Biz info@abstractdata.Biz version 1.0 october 2011 64&3(6*%& "%&3&"$5*7&4)"1&3 3-stage shaping, folding & feedback module with dedicated cv control and dual outputs.
Page 2 of 7 stage 1 mod: vertical waveshaping for subtle phasing and pwm-style effects stage 2 mod: inward wavefolding for additional harmonics and harder pwm-style effects stage 3 mod: feedback and saturation amount fed back into stage 1 input gain/atten: pre-effect gain/attenuation up to +/- 50% a...
Page 3 of 7 calibration point: removes dc offset at both outputs. Factory calibrated to 0v dc (please see ‘calibration’ on page 7 of this guide) power connector: doepfer-style 16-pin idc socket. The ade-10 uses the doepfer standard for power connection and cable orientation. The red stripe on the su...
Page 4 of 7 introduction: the ade-10 is a 3-stage analog waveshaping, wavefolding and feedback effect in a 10hp module in the eurorack format. The 3 stages are arranged in series so any 1 stage can be operated independently or combined with either of the other 2 stages. All 3 stages can be modulated...
Page 5 of 7 the diagram below shows an approximation of the effect that each stage of the ade-10 has on each of the three primary waveform types when the control for each stage is used in isolation and turned to full. N.B. The effect each stage has on the input waveform is ‘cyclical’ - i.E. As the k...
Page 6 of 7 the external cv inputs of the ade-10 should accept any cv, lfo or audio signal within a range of approximately +/-10v, however, cv content outside the range of 0-5v dc will be clipped and blocked internally. The diagram below shows how a single +/-5v (10v peak to peak) ac sine wave used ...
Page 7 of 7 hardware: controls (left): stage 1 mod (manual) stage 2 mod (manual) stage 3 mod (manual) input gain/atten controls (right): stage 1 cv (external) stage 2 cv (external) stage 3 cv (external) output gain/atten inputs (signal): 1x dc, approx. +/-10v max. (3.5mm mono socket) inputs (cv): 3x...
