ABTronic PTZ-715WP User Manual - page 3
Transmision baudrate settings:
●
1200 b/s
DIP7 = ON, DIP8 = OFF
●
2400 b/s
DIP7 = OFF, DIP8 = OFF
●
4800 b/s
DIP7 = ON, DIP8 = ON
●
9600 b/s
DIP7 = OFF, DIP8 = ON
Protocol settings:
●
PELCO-P
DIP9 = ON
●
PELCO-D
DIP9 = OFF
2.2 RS-485 interface configuration
ATTENTION: Requires the
PCR-485/P
remote control kit.
To set data transmission parameters using RS-485 interface, set the DIP10 to position OFF
and use the
PCR-485/P
remote control kit.
●
Switches configuration
DIP10 = ON
●
RS-485 interface configuration
DIP10 = OFF
After connect the
PCR-485/P
remote control kit you have to set the required parameters, and next
execute the following keys combination:
1. Keep pressed the
PRESET
key for 3 seconds,
2.
Press the
SETUP
key.
After this sequence of operations the device will confirm the end of configuration procedure
by display the „OK” information.
Example: 2+4+16 = 22. Address is 22.