Abtus AVS-1200C/V2 Owner's Manual

Summary of AVS-1200C/V2

  • Page 1

    * specifications are subject to changes without notice. Specifications multi media controller abtus singapore pte ltd www.Abtussingapore.Com model: avs-1200c/v2 programmable 2 x configurable com ports provide control of projector/plasma/ multi media controller av switcher via rs-232 commands configu...

  • Page 2

    Detail connection and configuration of the av projection system with avs-1200cv2 and avs-1200sv2 user operation guide product description system diagram panel overview * specifications are subject to changes without notification the abtus avs-1200c/v2 is a high performance multi media controller des...

  • Page 3: Av1200C

    User operation guide remote control mode programming mode “panel tab” this allows programmer to assign the button function name as according to the physica control panel. Note only button 2 to 7 are allows for assignment as the rest fixed with default function. Buttons “function name” can be assign ...

  • Page 4

    User operation guide programming mode “layer” when “enable” this allow second layout command to be configure accordingly “hex code” command code entry for the relative button, only hex code is allows “transmitter” com 2 allows ir or serial to be transmitted in the case if either one of the two is no...

  • Page 5

    User operation guide programming mode programming mode “serial” this allow configuration of com3 communication parameter i.E. Baud rate, data bit, parity bit and stop bit of the controlled av switcher. Default parameter for avs-1200sv2 is as followed: baud rate: 9600 data bit: 8 parity bit: none sto...

  • Page 6

    User operation guide programming mode programming mode “clock setting” check on “use pc time” to set time in 12 or 24 hour format with reference to pc time or manually. “auto timer off and reset” “auto time off” function will set the control to shut down when time up. Example: after 8pm, system will...

  • Page 7

    User operation guide programming mode programming mode “delay time” “delay time” setup allows setting of delay time between switching function of projector. Example: projector on “warm up time”, projector off “cool down time” and “projector input switching interval time” all above timing defer from ...

  • Page 8

    User operation guide programming mode programming mode uploading of program file once programming is done, uploading can be done as followed: connect up the pc serial to the configuration com port of the avs-1200cv2 with the communication parameter set as stated above. Then click “connect” to establ...